Operating instructions

8
7
5
4
2
1
0
69
Remote Operation
Answering Device
Stops re-recording of a greeting
message
Erases a specific message
Erases all messages
Changes to the TEL mode
Turns message transfer/pager call
for incoming messages ON
Turns message transfer/pager call
for incoming messages OFF
Skips the greeting message
Repeats a message
Skips a message
New message playback
All message playback
Re-records a greeting message
Continues operation
Operating from a remote location
The following operations can be performed from a remote location using a touch tone telephone.
Program the remote operation ID (see next page) and set the unit to the TAD/FAX mode before going
out (p. 61).
Dial Key Remote command Page Dial Key Remote command Page
73
71
71
71
71
72
See note
below
6 2
6 1
6 0
5
4
9
72
72
72
73
73
73
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
Answering Device
Remote Operation
Notice of Remote Operation
Fold here
1. Call your unit.
2. Enter the remote operation ID
during the greeting
message.
●
The new recorded
messages will be played
automatically.
OR
Wait 4 seconds, and all the
recorded messages will be
played back.
3. Press the remote command
key(s) (see reverse side) for
further operations.
●
The remote operation is
available only from a touch
tone telephone when the unit
is in the TAD/FAX mode.
●
When the unit is in the TEL
mode, call your unit and wait
for 20 rings. The answering
device will temporarily answer.
Enter the remote operation ID
during the greeting message.
The unit will switch to the
TAD/FAX mode.
●
To send a document, press
. When a fax tone is
heard, start transmission.
●
Press keys firmly.
9
Note:
●
During remote operation, the unit will stop and two beeps will be heard in the following conditions:
— 2 minutes 40 seconds after your unit answered.
— Every 2 minutes 40 seconds after pressing any command key.
To listen to further messages dial within 10 seconds after hearing the two beeps.
8