TGA914E_for_TG9140E(e).book Page 1 Friday, July 28, 2006 11:55 AM Operating Instructions for Cordless Camera Model No. KX-TGA914E Indoor Use Only Cordless Camera Please read these Operating Instructions before using the unit and save for future reference.
TGA914E_for_TG9140E(e).book Page 2 Friday, July 28, 2006 11:55 AM Table of Contents Introduction Feature highlight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Preparation Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TGA914E_for_TG9140E(e).book Page 3 Friday, July 28, 2006 11:55 AM Introduction Feature highlight Camera monitoring using the handset Important: L In these operating instructions, the term “handset” is used to refer to the KX-TGA910E. You can monitor the room where the cordless camera is located when: – you access the cordless camera using the handset (page 10). – the cordless camera pages the handset when it detects sound (page 11).
TGA914E_for_TG9140E(e).book Page 4 Friday, July 28, 2006 11:55 AM Introduction Important information General L Use only the AC adaptor included with this product. L Do not connect the AC adaptor to any AC outlet other than a standard 220–240 V AC outlet. L This product should not be used near emergency/intensive care medical equipment and should not be used by people with pacemakers. L Care should be taken that objects do not fall onto, and liquids are not spilled into, the unit.
TGA914E_for_TG9140E(e).book Page 5 Friday, July 28, 2006 11:55 AM Introduction please take these products to designated collection points, where they will be accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your local retailer upon the purchase of an equivalent new product.
TGA914E_for_TG9140E(e).book Page 6 Friday, July 28, 2006 11:55 AM Preparation Controls A B G C E F H D A B C D E F G H Antenna Camera lens MIC (Microphone) Call button Indicator DIP switches Speaker PROG. (Program) Understanding the cordless camera indicator The cordless camera indicator shows the status as follows. Status Description Red (flashing rapidly) L The cordless camera is not registered. Register the cordless camera (page 13). L The cordless camera is out of range.
TGA914E_for_TG9140E(e).book Page 7 Friday, July 28, 2006 11:55 AM Preparation Setting up the cordless camera Connecting the AC adaptor and the call button Connect the AC adaptor cord by pressing the plug firmly (A). Connect the call button cord until it clicks into the unit (B). L Use only the included AC adaptor. B A Hooks (220–240 V, 50 Hz) Note: L The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.
TGA914E_for_TG9140E(e).book Page 8 Friday, July 28, 2006 11:55 AM Preparation Adjusting the cordless camera lens angle Aim the camera lens by pushing the tab (A) and rotating the lens up or down. L Using the handset, confirm that the area you want to monitor from the cordless camera is displayed (page 10). Approx. 40° A Approx. 40° Note: L Do not touch the camera lens (page 6). 8 Helpline Tel. No.: U.K. 08700 100 076 R.O.I.
TGA914E_for_TG9140E(e).book Page 9 Friday, July 28, 2006 11:55 AM Preparation Setting the DIP switches DIP switches (Default position: ON) ON 1 2 3 OFF*1 You can set the following functions by using DIP switches 2 and 3. DIP switch 1 is not used for any settings. Slide each switch with a pointed object such as a pen as necessary. DIP switch Function 1 ON (default) – OFF*1 – – 2 Image orientation Normal Upside down 3 Speaker volume Normal Low *1 Slide the switch down.
TGA914E_for_TG9140E(e).book Page 10 Friday, July 28, 2006 11:55 AM Camera Monitoring Camera monitoring using a handset – while you are on a call with the handset. (In this case you will hear 2 tones and z will flash on the handset.) L You cannot make a monitoring connection via a DECT repeater. Monitoring the cordless camera from a handset Handset 1 2 With a handset, you can monitor the image and sound of the room where the cordless camera is located.
TGA914E_for_TG9140E(e).book Page 11 Friday, July 28, 2006 11:55 AM Camera Monitoring Press {s} to answer the page. L You can monitor the room where the camera is located. Handset display item for camera monitoring Displayed Meaning item Example: 8 The handset is connected to the cordless camera. When flashing: The cordless camera is paging the handset. (It detects sound or its call button is pressed.
TGA914E_for_TG9140E(e).book Page 12 Friday, July 28, 2006 11:55 AM Camera Monitoring 4 Handset: When you finish monitoring, press {ih} or place the handset on the base unit or charger. With a handset, you can set the camera settings while monitoring. Setting the audio detection sensitivity The cordless camera features a sensor that detects human voices such as a baby cry. Sounds other than human voices may be difficult to detect.
TGA914E_for_TG9140E(e).book Page 13 Friday, July 28, 2006 11:55 AM Useful Information Cancelling the cordless camera Using a handset registered to the same base unit, you can cancel the registration of a registered cordless camera. 1 2 3 4 J (centre of joystick) i L i L 5 L i “Yes” i L L “Please Wait...” will be displayed and a long beep will sound. 6 Registering the cordless camera The included cordless camera and base unit are preregistered.
TGA914E_for_TG9140E(e).book Page 14 Friday, July 28, 2006 11:55 AM Useful Information Wall mounting The cordless camera can be mounted by the standard mounting or upside down mounting. CAUTION: L Mount the cordless camera on the stable location where the unit can be adequately supported when installing. L The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet.
TGA914E_for_TG9140E(e).book Page 15 Friday, July 28, 2006 11:55 AM Useful Information Mounting the cordless camera on the wall Standard mounting 1 Drive the screws (not included) into the wall at a recommended height of 1.8 m or below using the wall mount template as a guide (page 16). 2 Mount the cordless camera (A), then slide it down (B) and to the right (C) until it is secure. L To aim the camera lens, see page 8.
TGA914E_for_TG9140E(e).book Page 16 Friday, July 28, 2006 11:55 AM Useful Information About the screws for wall mounting L Use the recommended screw size below. L Drive the mounting screws leaving enough length from the wall to hook the cordless camera. Space Max. 9.3 mm Max. 4.5 mm Removing the wall-mounting adaptor Press and hold the hold button (A) on the left side of the wall-mounting plate. Slide the cordless camera to the right (B).
TGA914E_for_TG9140E(e).book Page 17 Friday, July 28, 2006 11:55 AM Useful Information Troubleshooting Problem Cause & solution The cordless camera does not work. L Check the connections (page 7). L The cordless camera is not registered to the base unit. Register the cordless camera to the base unit (page 13). The cordless camera’s indicator is flashing red. L The cordless camera is not registered to the base unit. Register the cordless camera to the base unit (page 13).
TGA914E_for_TG9140E(e).book Page 18 Friday, July 28, 2006 11:55 AM Useful Information Problem Cause & solution The handset speaker and/or the cordless camera emit a howling noise while monitoring. L Move the handset away from the cordless camera. When using the handset speakerphone to have an intercom call with the cordless camera, sound cuts in and out and you have difficulty hearing the other party. L Lower the speaker volume by pushing the joystick down. 18 Helpline Tel. No.: U.K.
TGA914E_for_TG9140E(e).book Page 19 Friday, July 28, 2006 11:55 AM Useful Information Specifications L The illustrations used in these operating instructions may differ slightly from the actual product. N Standard: DECT (Digital Enhanced Cordless Telecommunications) N Number of channels: 120 Duplex Channels N Frequency range: 1.88 GHz to 1.
TGA914E_for_TG9140E(e).book Page 20 Friday, July 28, 2006 11:55 AM Sales and support information Customer Care Centre L For customers within the UK: 08700 100 076 L For customers within the Republic of Ireland: 01289 8333 L Visit our website for product information: www.panasonic.co.uk L E-mail: customer.care@panasonic.co.
