-
Panasonic Network Camera Technical Notes Ver. 2.0 3 April, 2003 Panasonic Communications Co.,Ltd. Copyright © 2003 Panasonic Communications Co., Ltd.. All rights reserved.
-
History of Revisions Date 2002.9.26 2003.4.3 Revision 1.00 2.00 Revised: First English Revision Add parameter for HCM280. Add New CGI command Copyright © 2003 Panasonic Communications Co., Ltd.. All rights reserved.
-
１．NOTICE The purpose of this document is to help users who need to include live images from Panasonic Network Cameras on their web pages, or control Panasonic Network Cameras using CGI commands. This document is provided for use by people who are familiar with HTML. In no event Panasonic shall make any kind of warranty or representation and be responsible for any expenses, damages or loss incurred by using this information.
-
３．COMMAND LIST To interact with the camera, CGI commands are very useful. The basic format for a CGI command is http://IPADDRESS/ CGIcommand ? Option1 = A & Option2 = B of course with no spaces. 3.1 IMAGE VIEWING One of the CGI commands “ImageViewer” enables you to a embed LIVE or STILL images. You can also specify the resolution, Quality, refresh interval time and showing Title of the images.
-
3.2 CAMERA CONTROL The CGI Command “nphControlCamera” is to be used for Camera Control such as PAN/TILT/ZOOM, PAN SCAN, Auto Focus and BRIGHTNESS. KX-HCM8 can be set with BRIGHTNESS only. ZOOM function and Auto Focus function is used for KX-HCM280 only.
-
*4 When adjusting a focus manually, it is necessary to use the parameter shown below.
-
3.3 Motion image Getting The CGI Command “nphMotionJpeg” is to be used for Getting motion image as MIME formatted data. You can record these images. You can also view these images using acceptable viewer like Netscape4.7.. *Note: Please take care to disk space when you record images in your PC. If the space of your PC becomes not enough, your PC will become unstable or will be downed.
-
You can record and view images using extracted JPEG data. (4) End Close(Disconnect) the socket. 3.4 Still image Getting The CGI Command “SnapshotJPEG” is to be used for Getting still image. . SnapshotJPEG Parameters Settings Resolution 160x120, 320x240, 640x480 Motion ( Favor motion ) Standard Clarity ( Favor clarity ) Quality Example SnapshotJPEG?Resolution=320x240&Quality=Standard Copyright © 2003 Panasonic Communications Co., Ltd.. All rights reserved.
-
４．SAMPLE Web Page The following section shows an example of a sample web site with a Live image from a Panasonic Network Camera. The Sample Web Page Consists of 3 frames: the Live Image frame at “right”, Camera “Control” Frame at upper left and “Message” frame at lower left hand side to display messages from the Camera. For the image of Camera Control Pad, “pad.gif” is used on this page.
-
Source Code of Sample Web page Control1 Frame 
ManualShelf © 2013-2026
|
