Operation Manual

Setting up the Scanner
12
 Power turn-on sequence
1
Turn on the power of the scanner.
• Connect the power cord to the AC adaptor.
• Connect the AC adaptor to the scanner.
• Plug into an AC outlet.
• Push the power switch.
• The LED (Green) will blink for about 30
seconds and then it will become steady.
Note:
• Install the software first.
 About LED
The status of the scanner can be established by the condition of the two LED indicators shown in the table below:
*1
It will take about 30 seconds to initialize the scanner.
LED (Green)LED (Red)Status
ON OFF Ready
Blink (Slow) OFF Sleep
ON Blink (Slow) Caution
Blink (Slow) Blink (Slow) Caution/Sleep
ON ON Error
Blink (Fast) OFF Warming up
*1
AC adaptor
Power cord
Power switch ( )
USB cable
Ready
Error
Start / Stop
LED (Green)
LED (Red)