Datasheet
JS-M
1
ds_61211_0000_en_jsm: 061006J
SPECIFICATIONS
ORDERING INFORMATION
GLOBAL STANDARD
TERMINAL PITCH
AUTOMOTIVE
POWER RELAY
JS-M RELAYS
mm inch
16.4
.646
16
.630
22
.866
1c
FEATURES
• Low pick-up voltage for high ambient
use
• Sealed construction
• Global standard terminal pitch
• Usable at high temperature: 85°C
185°F
TYPICAL APPLICATIONS
• Power-window
• Car antenna
• Door lock
• Intermittent wiper
• Interior lighting
• Power seat
• Power sunroof
• Car stereo
•Horn
• Lift gate, etc.
Contact
* Measured after operating 5 times at the rated load
Coil
Contact rating
Characteristics
#1 This value can change due to the switching frequency, environmental conditions,
and desired reliability level, therefore it is recommended to check this with the
actual load.
Remarks
*
1
Measurement at same location as “Initial breakdown voltage” section
*
2
Detection current: 10mA
*
3
Excluding contact bounce time
*
4
Half-wave pulse of sine wave: 11ms; detection time: 10μs
*
5
Half-wave pulse of sine wave: 6ms
*
6
Detection time: 10μs
*
7
Refer to 6. Conditions for operation, transport and storage mentioned in
AMBIENT ENVIRONMENT (p. 19, Relay Technical Information).
Standard type
High capacity
type
Arrangement 1 Form A, 1 Form C
Contact material AgSnO
2 type
Initial contact resistance
(By voltage drop 6 V DC 1 A)
*Max. 100 mΩ *Max. 100 mΩ
Contact voltage drop Max. 0.2 V (at 10 A 12 V DC)
Rating
Nominal switching
capacity
10 A 16 V DC
(resistive)
15 A 16 V DC
(resistive)
Max. carrying current
25 A (at 20°C 68°F for 2 minutes)
15 A (at 20°C 68°F for 1 hour)
20 A (at 85°C 185°F for 2 minutes)
10 A (at 85°C 185°F for 1 hour)
Max. switching power 160 W
Max. switching voltage 16 V DC
Max. switching current 10 A
15 A
(10 A max.
at 85°C)
Min. switching capacity
#1
1 A 12 V DC
Expected
life (min.
ope.)
Mechanical life
(at 180 cpm)
10
7
Electrical
(at 15 cpm)
Resistive 10
5
N.O.: 10
5
N.C.: 5×10
4
Nominal operating power 640 mW
Load
Standard type High capacity type
Form A
Form C
Form A
Form C
N.O. N.C. N.O. N.C.
Max. carry current 15 A 15 A 15 A 15 A 15 A 15 A
Max. make current 25 A 25 A 10 A 50 A 50 A 15 A
Max. break current 10 A 10 A 10 A 15 A 15 A 15 A
Max. operating speed
(at rated load)
15 cps.
Initial insulation resistance*
1
Min. 100 MΩ (at 500 V DC)
Initial
breakdown
voltage*
2
Between open contacts 750 Vrms for 1 min.
Between contacts and
coil
1,500 Vrms for 1 min.
Operate time*
3
(at nominal voltage) Max. 10 ms
Release time (without diode)*
3
(at nominal voltage)
Max. 10 ms
Shock resistance
Functional*
4
Min. 98 m/s
2
{10 G}
Destructive*
5
Min. 980 m/s
2
{100 G}
Vibration resistance
Functional*
6
10 Hz to 55 Hz
at double amplitude of 1.6 mm
Destructive
10 Hz to 55 Hz
at double amplitude of 2 mm
Conditions for operation,
transport and storage*
7
(Not freezing and
condensing at low
temperature)
Ambient
temp.
–40°C to +85°C
–40°F to +185°F
Humidity 5% R.H. to 85% R.H.
Mass Approx. 12 g .423 oz
Ex. JSM
Contact arrangement
Note: Standard packing: Carton: 100 pcs. Case: 500 pcs.
1a: 1 Form A
1: 1 Form C
Nil: Sealed construction
F: Flux-resistant type
4: Standard type (10 A)
5: High capacity type (15 A)
12 V
Protective construction Coil voltage (DC) Contact material
1a F 12V 4