Operating instructions

Section 700 - Operation Chapter 4. User Maintenance
ICX-35-700 ICX (International), March/1999 87
Hardware Requirements
•N/A
Considerations
•N/A
Set Mode Schedule
Description
(For a description of Automatic Day/Night System Mode, see “Automatic Day/Night Mode” on page
37.)
You can set the System to automatically enter None, Day 1, Day 2, Night, Night (1), or Night (2)
modes based upon mode patterns. You can define up to 3 patterns with up to 5 modes for each day.
(This menu allows the setting of the patterns.)
Operation
To set the Mode Schedule:
7. Enter the Message Key ID code.
Notes:
The ID code may contain up to 16 digits and contain
0
,
1
-
9
,
*
,
#
, pause (
REDIAL
key).
To clear an entry or existing data, press the
FL/R
key.
8. Press the
HOLD
key to store the entry. Next extension number displays
9. To set additional Message Key ID codes, press the volume
up or down key or press the
HOLD
key to move to the
desired extension.
Desired extension number displays
10. Repeat steps 7-9 until all Message Key ID codes are set.
11. Press the
MEMORY
key to exit the entry mode. MSGID - EXT Number displays
12. To return to the top menu level (
81
), press the
PROG
key.
OR...
To exit the User Maintenance mode, press the
ON/OFF
key.
81-
User MAINT displays
OR...
ON/OFF
LED goes off
Action Result
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See “To enter User Maintenance mode:” on
page 75.)
81-
User MAINT displays
2. At the
81
level, enter
07
.
3. Press the
HOLD
key. 8107-
System Mode displays
Action Result