Operating instructions

232 ICX (International), issued March/1999 ICX-35-700
Chapter 6. DSLT Features Section 700 - Operation
To set Manual Camp-on:
To answer a Camp-on (Call Waiting) signal:
Hardware Requirements
•N/A
Considerations
• You can transfer an outside call to a busy extension using Camp-on. See “Camping a Call Onto a
Busy Extension” on page 230.
Conference Calls
CPC-96, CPC-288, and CPC-576 Version 3.0
Description
Conference Calls allow you to add another party to an existing conversation. With the standard
system configuration, up to 3 parties can be included in a conference call at any one time. If the
optional Conference Card is installed, additional parties up to a total of 8 can participate in a
conference call.
The CPC Version 3.0 software release allows any combination of extensions and trunk lines be in the
conference as long as the original extension is in the conference and the total number of parties does
not exceed 8. With CPC Version 3.0 software, only one operation is used to establish and add to a
conference. You simply have to place the current call on hold, dial the next party and press the CONF
key. No different operation or access code is required to add additional parties to the call.
When no optional conference card is installed, the system supports the following types of three-party
conference calls:
•3 extensions
Action Result
1. Lift the handset or press the
ON/OFF
key. Intercom dial tone
2. Dial the extension number. Busy tone
3. Enter the Camp-on (Call Waiting) code (default =
2
[UK/
HK] or
2#
[Taiwan, Malaysia, Indonesia]).
• Called party hears alert tone
• Calling party hears ringback tone
4. Remain on the line until the called party answers.
Action Result
1. Replace the handset or press the
ON/OFF
key.
2. Lift the handset or press the
ON/OFF
key again to be con-
nected to the waiting call.
OR....
Press the
HOLD
key.
• Current call placed on hold
• Connected to waiting call