Operating instructions

148 ICX (International), issued March/1999 ICX-35-700
Chapter 5. Key Telephone Features Section 700 - Operation
To establish a two-party private conversation from a 3-party conference (Version 3.5
and higher):
To remove a Busy Tone (Hang up) from an 8-party conference (Version 3.5 and
higher):
Hardware Requirements
• A Conference Card (VB-44120) must be installed in the System in order to conference more than
three parties.
Considerations
• **If all the internal parties hang up, the conference call will be disconnected. If the internal party
remains in the conversation, the conference call remains in progress.
• When three parties are conferenced, a built-in 3-party conference circuit is used. If no 3-party
conference circuit is available, a conference cannot be established.
6.
For 3-party Conference Call Only:
To release a conference member, press
PROG + 1
to release
conference member 1 or press
PROG + 2
to release confer-
ence member 2, etc.
Note:
The conference member numbers are shown on the
display.
(Available up to 3-party conference. Not
available for 4-party or more conferenc-
ing)
7. To drop out of the conference call, hang up. (See
**
Consideration below)
Action Result
1. While on a call, press the
CONF + 1 (2)
to have a private
conversation with the CNF 1 (2) party as shown on the dis-
play.
You and the selected party are in a sepa-
rate conversation from the other confer-
ence parties.
2. To reestablish the conference, press
CONF
.
CNF1:CO XXX
or
EXT XXX
and
CNF2:CO YYY
or
EXT YYY
displays
(where XXX = first party and YYY = sec-
ond party)
Action Result
1. During an conference with more than 3 parties, press
CONF + (n) (
where
n
is the number 1-7 for the conference
parties) to individually select a conference party.
The other party is placed on hold.
2. If you did not select the conference party that is giving busy
tone, re-enter the conference by pressing the
CONF
key.
CONF Members: X
(where X = 4-7
party conference) displays
3. If you selected the conference party that is giving busy tone,
hang up and then go off-hook again and press the
CONF
key to re-enter the conference call.
CONF Members: Y
(where Y = 4-6
party conference) displays
Action Result