Operation Manual

Dialling out to Sites (Ad-Hoc Mode) (On-Site
Operation)
You can dial out to sites using the remote control of the HD Visual Communication Unit. After connecting to
the
HDVC-MPCS, you can dial out
to a registered site by entering the ID number of its profile using the remote
control.
Note
• To use this feature, an Ad-Hoc conference must be in progress.
Dialling out to Sites
1. Join a conference using dial in.
2. Press [#][X][X][X].
• The HDVC-MPCS starts to dial out to the sites assigned to the conference number [X][X][X].
Note
• The conference number [X][X][X] should correspond
to the ID number of the profile (101-110) set
in the profile settings.
• You can dial out any number of times during a conference. Therefore, it is possible to dial out again
to an unconnected site.
Disconnecting Other Sites from the Conference
1. Press [#][1][9][9].
• All sites are disconnected from the conference except for the site that performed this operation.
28 Operating Instructions
Basic Operation