Operation Manual

Joining a Conference (Dial In) (On-Site Operation)
If you call the IP address of the HDVC-MPCS for a conference or Terminal ID of the KX-VC Series NAT
Traversal Service (dial in) from the HD Visual Communication Unit or the HD Visual Communication Mobile,
you can join a conference. For details, refer to the Operating Manual or User Manual of the HD Visual
Communication Unit or the Help of the HD Visual Communication Mobile.
Note
• When in Normal Mode, you cannot join a conference if you call from a site that is not in the
"Participant" list.
• The IP address of the HDVC-MPCS for a conference is specified in "Network Status" in the
maintenance menu list.
Disconnecting from a Conference (On-Site
Operation)
If you end a conference using the HD Visual Communication Unit or the HD Visual Communication Mobile,
you can disconnect from the HDVC-MPCS conference. For details, refer to the Operating Manual or User
Manual of the HD Visual Communication Unit or the Help of the HD Visual Communication Mobile.
Selectable Video Source (Presentation Mode)
(On-Site Operation)
By connecting your computer
or sub video camera to the HD Visual Communication Unit, you can show your
computer’s screen or video camera image to other sites in a conference. Remote control operation from the
site you want to show is required.
1. Select the image you want to display.
Computer’s screen:
1. Press [PC].
• The computer’s screen is displayed. The same screen is displayed on other sites’ displays.
Sub video camera’s image:
1. Press [Camera Sub].
• The sub video camera’s image is displayed. The same image is displayed on other sites’ displays.
2. Press [Camera Main] to restore the original image.
Note
• When using software version 3.00 or
earlier for the HD Visual Communication Unit, it is necessary
to perform the following procedure for displaying the site's image in full screen.
1. Press [
][1][0].
• The site’s image is displayed in full screen.
2. Select the image you want to display.
3. Press [Camera Main] to restore the original image.
4. Press [ ][1][1].
• The screen layout returns to the layout pattern in use before step 1 was performed.
Operating Instructions 27
Basic Operation