Operation Manual

1. Click "Add".
2. Enter the site's IP address or the Terminal ID of the KX-VC Series NAT Traversal Service to dial out
to.
3. Click "OK".
• The sites that will be dialled are displayed in the "Dial Out Endpoint List".
Note
• You cannot select more sites than the number of registered license ports.
• You cannot add sites which have the same IP address or the same Terminal ID for the KX-VC
Series NAT Traversal Service.
• Perform the following operation if you want to delete sites from the "Dial Out Endpoint List".
1. Select the sites you want to delete.
2. Click "Delete".
3. Click "OK".
6. Click
"Start Conference".
• The sites in the "Dial Out Endpoint List" are dialled out to. The conference starts when the sites
answer.
Operation During a Conference
Changing Display Position of Site Images (Normal Mode Only)
Note
• To perform this operation, "Display Position Switching" in the profile must be set to "Manual". For
details, refer to "Profile Settings".
1. Click the "Home" screen selecting tab.
• The Home screen is displayed.
2. Click the
"Conference Operation" tab in the operation area.
• The conference operation screen is displayed.
3. Select the sites for which you want to change the display position, from the "Active Participant List".
Operating Instructions 19
Basic Operation