Operation Manual

Manual Switching (Normal Mode Only)
You can change the display position
of site images during a conference to one of the following 3 positions. For
details, refer to "Changing Display Position of Site Images (Normal Mode Only)".
• The first priority position
• The last priority position (e.g., The eighth priority position for CP8)
• Hide
Fixed Display Position (Normal Mode Only)
The display position of site images can be preconfigured by profile. For details, refer to "Profile Settings".
Note
• The order of registration corresponds with the display priority.
Presentation Mode
A site’s image can be displayed in full screen display. This is useful for sharing images from the computer or
the sub video camera among conference participants. For details, refer to "Selectable Video Source
(Presentation Mode) (On-Site Operation)".
Settings for HD/SD Video
The HDVC-MPCS sends either HD or SD video, depending on the bandwidth setting in the HD/SD video
settings, the types of
connected devices, and available bandwidth. It is possible to configure the screen layout
to use during a conference and set the site name display for each video type. For details, refer to "Settings
and Registration".
KX-VC Series NAT Traversal Service
"KX-VC Series NAT Traversal Service" is a service that allows you to easily set up and operate an affordable
communication environment for the HD Visual Communications System. Also, you can assign a unique number
(Terminal ID) to the unit, which allows the unit to be called with a unique, 7-digit number instead of the IP
address. This means communication can be initiated as if calling a telephone. To use this service, registration
is necessary. For details, contact your dealer.
Message from KX-VC Series NAT Traversal Service
When you receive a message from KX-VC Series NAT Traversal Service, the message "Please check a
message by Web console" is displayed on the site’s screen when you join a conference. Also, the
Message button on the screen of the HDVC-MPCS Console becomes active (changes from grey to blue). By
clicking the button, messages about the failure state and information about the service period of KX-VC Series
NAT Traversal Service is displayed. Be sure to check these messages.
14 Operating Instructions
Preparation