Quick Start Guide

43
VQT2M90
This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is
reopened or the viewfinder is extended.
≥ Start time will not shorten if there is no SD card inserted.
Start time will be shorten if the [Built-inMemory] is selected in the [MEDIA SELECT], even if
there is no SD card inserted.
Start time will be shorten if the [HDD] is selected in the [MEDIA SELECT], even if there is
no SD card inserted.
≥ Change the mode to or .
1Set [QUICK START] to [ON].
2 Close the LCD monitor and retract the
viewfinder while the mode is set to
or .
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor or extend
the viewfinder.
The status indicator A lights red and the unit
is put into recording pause.
≥ When in quick start standby mode about 80% of the power used in recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
≥ Time for quick start will be more than 0.6 seconds slower when digital cinema is used.
≥ Depending on the recording conditions, time for quick start may be more than 0.6 seconds
slower in still picture recording mode.
≥ It may take some time for automatic white balance to adjust.
≥ In the quick start mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 42) is set to [5 MINUTES] and the unit automatically goes into quick
start standby mode, close the LCD monitor and viewfinder and then open the LCD monitor
or extend the viewfinder again.
≥ Turn the unit off using the power button.
≥ Quick start standby mode cannot be released by the remote control.
Please refer to page 49.
[QUICK START]
[OFF]/[ON]
[REMOTE CONTROL]
[OFF]/[ON]
HDC-SD700&TM700&HS700EB-VQT2M90_mst.book 43 ページ ２０１０年２月１６日 火曜日 午前９時６分