Quick Start Guide

132
VQT2M90
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ Remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC
adaptor. Then about 1 minute later, turn on the unit
again. (Conducting the above operation while the
media is being accessed may damage the data on
the media.)
≥ If normal operation is still not restored, detach the
power connected, and consult the dealer who you
purchased this unit from.
Item other than the
touched one is
selected.
≥ Calibrate the touch screen. (l 47)
The remote control
does not function.
≥ [REMOTE CONTROL] of the [SETUP] is [OFF].
(l 49)
≥ The button-type battery of the remote control may be
run out. Replace it with a new button-type battery.
(l 49)
The remaining time
indication or the
elapsed time
indication is not
shown.
≥ [DISPLAY] of the [SETUP] is [OFF]. (l 41)
The unit arbitrarily
stops recording.
≥ Use an SD card that can be used for motion picture
recording. (l 22)
≥ The recordable time may have shortened due to the
deterioration of the data writing speed or repeated
recording and deletion. Using the unit, format the SD
card, built-in memory or HDD. (l 46)
≥ If [AGS] is [ON], record in the normal horizontal
position or set [AGS] to [OFF]. (l 66)
≥
If the unit is exposed to strong vibrations or shocks
while recording on HDD, recording may stop to
protect the HDD. If the unit is used in a place with
loud sounds, the recording may stop due to sound
vibrations. Recording data on an SD card is
recommended in these places.
HDC-SD700&TM700&HS700EB-VQT2M90_mst.book 132 ページ ２０１０年２月１６日 火曜日 午前９時６分