Operating instructions

36
VQT1H64
Setup
The menu screen transition is the same as when
the buttons on the main unit are used.
1 Press the MENU button.
2 Select a menu item.
≥ Use the direction buttons (3,4,2,1) and
ENTER button in place of the cursor button on
the main unit.
3 Press the MENU button to exit
the menu screen.
Setting date and time
When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥ Move the cursor button up or down to select
[YES], press the cursor button and then
perform steps 2 and 3 below to set the date
and time.
If the screen shows the incorrect date and time,
then adjust it.
¬Rotate the mode dial to select .
1 Press the MENU button, then
select [BASIC] # [CLOCK SET]
# [YES] and press the cursor
button.
2 Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
≥ The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥ The 24-hour system is used to display the time.
3 Press the cursor button to enter
the selection.
≥ The clock function starts at [00] seconds when
the cursor button is pressed.
≥ After pressing the MENU button to finish the
setting, check the date and time display.
Operating with remote control
MENU
ENTER
MENU
ENTER
MENU
ENTER
HDCSD5-VQT1H64_eng.book 36 ページ ２００７年８月１日 水曜日 午後７時１６分