Quick Start Guide

10
VQT2A55 (ENG)
13 SD card open lever [OPEN]
14 Audio-video output terminal [A/V]
≥ Use the AV cable (only the supplied cable).
15 Component terminal [COMPONENT]
16 HDMI mini connector [HDMI]
17 Access lamp [ACCESS]
18 Card slot
19 SD card cover
20 Built-in flash
21 Lens (LEICA DICOMAR)
22 Lens hood
Rotate the lens hood counter-clockwise A to
remove it. In order to attach it, place into slot B,
and then rotate it clockwise C.
≥ Attach the MC protector or the ND filter of the
Filter Kit (VW-LF43NE; optional) in front of the
lens hood.
≥ When fitting the tele conversion lens
(VW-T4314H; optional) or the wide conversion
lens (VW-W4307H; optional), first remove the
lens hood.
23 Remote control sensor
24 Recording lamp
25 Video light
Lens cover A
≥The lens cover opens in
recording mode.
20 21
22
23
2425
Be careful about the following.
When 2 lens accessories, such as the ND filter
and tele conversion lens, are fitted and the
zoom lever is pressed toward the W side, the
4 corners of an image will be darkened.
(Vignetting)
(When fitting 2 lens accessories, first remove
the lens hood and then fit them.)
Attaching the lens cap
(Included in the Filter Kit
(VW-LF43NE; optional))
≥ When the filter kit (VW-LF43NE; optional) is
used, protect the lens surface while the unit
is not used with the lens cap supplied with
the filter kit.
≥ To attach or remove the lens cap, hold both
sides of the lens cap with the tips of your
finger and thumb.
HDCSD20&TM20&HS20EP-VQT2A55_mst.book 10 ページ ２００８年１２月１６日 火曜日 午後９時２３分