Operating instructions

Table Of Contents

- 49 -

∫ To change the peaking settings

If you set Focus Assist to ON by following either of the

procedures below, in-focus portions are highlighted with

color (Peaking G).

j Setting the menu item [FOCUS ASSIST 1] to

[PEAKING] or [BOTH] and pressing the USER button

to which <FOCUS ASSIST 1> is registered.

j Setting the menu item [FOCUS ASSIST 2] to [PEAKING] and pressing the USER button to

which <FOCUS ASSIST 2> is registered.

≥ You can set the peaking color and strength.

(When changing the peaking color)

Select the menu.

(When setting the peaking strength)

1 Select the menu.

2 Touch / to adjust settings.

≥ You can select a value between s7 and r7.

3 Touch [EXIT] to complete the setting.

(Notes on Focus Assist)

≥ Focus Assist is not possible in following cases:

j During Recording Check (l 68)

j During Freeze Frame (l 69)

j When color bars are displayed. (l 79)

≥ Focus Assist is canceled in following cases:

j If you turn the unit off

j When the mode switch position is changed

j (If you operate the USER button to which <FOCUS ASSIST 1> is registered)

When the setting of [FOCUS ASSIST 1] (l 48) is changed

j (If you operate the USER button to which <FOCUS ASSIST 2> is registered)

When the setting of [FOCUS ASSIST 2] (l 48) is changed

j When you set this unit to Auto Focus

≥ The magnified display and peaking are not displayed on recorded images.

≥ The magnified display and peaking are not displayed on a TV.

≥ Freeze Frame is not available when you use Focus Assist. (l 69)

≥ Peaking may not be displayed when you use Digital Zoom (l 67). To zoom in and use peaking at

the same time, we recommend increasing the magnification level of the magnified display by

setting [FOCUS ASSIST 1] to [BOTH] or by using the magnified display and the peaking function

in combination.

: [SW SETUP] # [PEAKING COLOR] # desired color

[Red]/[Blue]/[Yellow]/[White]

: [SW SETUP] # [PEAKING LEVEL] # desired setting

