Basic Operating Instructions

(ENG) DVQX1101

∫ It is not a malfunction in following cases

Others

Troubleshooting

The lens, the viewfinder or

LCD monitor fog up.

≥ This is due to condensation. This is not a malfunction. Please

refer to page 10.

Object seems to be warped. ≥ Object seems to be warped slightly when the object moves

across the image very fast, but this is because the unit is using

MOS for the image sensor. This is not a malfunction.

Power

Problem Check points

This unit cannot be turned

on.

This unit does not stay on

long enough.

Battery runs down quickly.

≥ Charge the battery again to ensure it is sufficiently charged.

(l 22)

≥ In cold places, the battery using time becomes shorter.

≥ The battery has a limited life. If the operating time is still too

short even after the battery is fully charged, the battery has

worn out and needs to be replaced.

This unit cannot be

operated though it is

turned on.

This unit does not operate

normally.

≥ Remove the battery or AC adaptor, wait about 1 minute and

then reconnect the battery or AC adaptor. Then about

1 minute later, turn on the unit again. (Conducting the above

operation while the SD card is being accessed may damage

the data on the media.)

≥ If normal operation is still not restored, detach the power

connected, and consult the dealer who you purchased this

unit from.

HC-X1_PP_Simple.book 45 ページ２０１６年１１月１日　火曜日　午前９時４８分