Basic Operating Instructions

4
DVQX1102
Note regarding the Power Management
function specified under COMMISSION
REGULATION (EC) No 1275/2008
implementing Directive 2009/125/EC of the
European Parliament and of the Council.
This device is designed and manufactured for
use at a broadcasting station and/or in a similar
environment.
This device is not equipped with a Power
Management function or the Power
Management function is set to OFF as it will
prevent the device from fulfilling its intended
purpose for the reasons below.
1. If the device is a Studio Camera, a Weather
Camera, a Mixer or other processor:
A Power Management function may
cause the device to suddenly stop
during recording or while On Air.
2. If the device is a Studio Monitor:
A Power Management function may
cause video for the confirmation of
whether a signal is normal, or whether
the signal has been lost, to be un-
viewable.
3. If the device is a Camera Recorder:
A professional camera recorder must be
able to start quickly at any time, but a
Power Management function will cause
an increase in the time taken to resume
from Stand-by mode.
∫ Cautions for use
Keep this unit as far away as possible from
electromagnetic equipment (such as
microwave ovens, TVs, video games etc.).
≥ If you use this unit on top of or near a TV, the
pictures and/or sound on this unit may be
disrupted by electromagnetic wave radiation.
≥ Do not use this unit near cell phones because
doing so may result in noise adversely
affecting the pictures and/or sound.
≥ Recorded data may be damaged, or pictures
may be distorted, by strong magnetic fields
created by speakers or large motors.
≥ Electromagnetic wave radiation generated by
microprocessors may adversely affect this
unit, disturbing the pictures and/or sound.
≥ If this unit is adversely affected by
electromagnetic equipment and stops
functioning properly, turn this unit off and
remove the battery or disconnect AC adaptor.
Then reinsert the battery or reconnect AC
adaptor and turn this unit on.
Do not use this unit near radio transmitters
or high-voltage lines.
≥ If you record near radio transmitters or
high-voltage lines, the recorded pictures and/
or sound may be adversely affected.
About connecting to a PC
≥ A USB 3.0 cable is not supplied with this unit.
Use a commercially-available double-
shielded USB 3.0 cable with a ferrite core.
If possible, we recommend using a cable with
a length of 1.5 m or less.
About using a headphone
≥
Excessive sound pressure from earphones
and headphones can cause hearing loss.
≥ Listening at full volume for long periods may
damage the user’s ears.
Make sure to use the supplied cords and
cables. If you use optional accessories, use the
cords and the cables supplied with them.
Do not extend the cords and the cables.
Do not spray insecticides or volatile
chemicals onto the unit.
≥ If the unit is sprayed with such chemicals, its
body may be marred and the surface finish
may peel off.
≥ Do not leave rubber or plastic products in
contact with the unit for a long time.
When you use the unit in a sandy or dusty
place such as a beach, do not let sand or
fine dust get into the body and terminals of
the unit.
Also, keep the unit away from sea water.
≥ Sand or dust may damage the unit. (Care
should be taken when inserting and removing
a card.)
About this unit
The unit and the SD card become warm
during use. This is not a malfunction.
HC-X1_EGC_Simple.book 4 ページ ２０１６年１１月１日 火曜日 午前１０時２１分