User manual

Alignment Procedures

Pedestal Setting

Equipment required: RF Video Gray Scale Generator

Panel Settings; Picture = Normal, White Balance = Cool, Aspect Ratio = 16:9

Figure 51 - Pattern Display

tep 1- Access the R, G and B cutoff settings and set them to “80”.

reen pixels

cess the RGB Sub Adjust, G Sub Bright setting and adjust G Sub

ntrol setting, Set Gun off to "3". (Only blue pixels

cess the RGB Sub Adjust, B Sub Bright setting and adjust B Sub

curs

oma Control setting, Set Gun off to "6". (Only red pixels

cess the RGB Sub Adjust, R Sub Bright setting and adjust R Sub

to PC / RGB signal. Repeat procedure (1 to 7) using PC

Step 2- Under the Chroma Control setting, Set Gun off to "5" (Only g

emitting).

Step 3- Ac

bright so that green pixel emission starts at black 2% area and no emission

occurs in the black 0% area.

Step 4- Under the Chroma Co

emitting.)

Step 5- Ac

bright so that blue pixel emission starts at black 2% area and no emission oc

in the black 0% area.

Step 6- Under the Chr

emitting.)

Step 7- Ac

bright so that Red pixel emission starts at black 2% area and no emission occurs

in the black 0% area.

Step 8- Change input

input signal.

114