User guide

INSTALLATION I (JOIST MOUNTING - I) CONTINUED
7. Finish ceiling work. Ceiling hole should be aligned
with the inside edges of the flange. (Fig.5)
IMPORTANT:
Remove the tapes from louver and springs
before installation. As shown below:
Tap«__w<6txX.
FV-13VKM3
FV-13VKS3 FV-08VKS3
FV-08VKM3
FV-13VK3 FV-08VK3
FV-05VK3
8. Insert the sensor unit into slot of the grille;
Fix the lead wire of sensor unit into the clasps
(3 positions). (FV-13VKM3 and FV-08VKM3).
(Fig.6)
9. Adjust high / low delay time preset switch and low
speed air volume preset switch (Fig.7).
Refer to switch indication on page 6. (FV-13VKM3,
FV-08VKM3, FV-13VKS3 and FV-08VKS3)
CAUTION:
Mount grille carefully so that lead wire of sensor
unit is not pinched.
Fig.7
10. Insert the mounting springs into the slot as
shown and mount grille to fan body. (Fig.8)
PDF created with pdfFactory Pro trial version www. pdffactory. com