Datasheet

Classification
No.
151-XB-JP00BE
Chip RF Jumper PRODUCT SPECIFICATION FOR INFORMATION
Subject
12 - 19
EXBD6JP000A
MATSUSHITA ELECTRONIC COMPONENTS CO., LTD.
8.7. Caution of flow soldering
We can not recommend the flow soldering to the product, because we are afraid that solder
bridge may happen owing to narrow pitch of it’s terminals.
8.8. Replacement with soldering iron
Note the followings in case of using soldering iron for replacement.
(1) The tip temperature should be less than 350
°C for the period within 3 s for each
terminal.
(2) The soldering iron tip should not touch the product directly.
8.9. Recommendable cleaning method
Solvents Isopropyl alcohol
Cleaning
method
Dipping
40
°C max., 5 min max.
Ultrasonic
1 min max.
(Power: 20 W/l max, frequency: 10 kHz to 100 kHz)
Residual fluxes after board washing may cause solder migration. Carefully check the status
of board washing.
Study type and amount of flux to be used in cleaning free soldering. Study type of
water-soluble flux and cleaning agent and dry condition when water washing is made.
Confirm they will not cause any troubles.
9. Notice for use
!
Notice for use
(1)This specification shows the quality and performance of the product in a unit
component. Before adoption, be sure to evaluate and verify the product mounted on
your circuit board.
(2)Use fail-safe design and ensure safety by carrying out the following items in cases
where it is forecast that the failure of the product gives serious damage to something
important like human life, for instance in traffic transportation equipment (trains,
cars, traffic signal equipment, etc.), medical equipment, aerospace equipment,
electric heating appliances, combustion and gas equipment, rotating equipment,
disaster and crime preventive equipment.
 Ensure safety as the system by setting protective circuits and protective
equipment.
 Ensure safety as the system by setting such redundant circuits as do not cause
danger by a single failure.
(3)The product is designed to use in general standard applications of general electric
equipment (AV products, household electric appliances, office equipment, information
and communication equipment, etc.); hence, it do not take the use under the
following special environments into consideration.