Operating instructions

13
Cleaning thoroughly
Cleaning with water
• Turn the shaver off and disconnect the AC adaptor.
1
Apply some hand soap and some
water to the system outer foil.
2
Press for more than
2 seconds to activate the sonic
vibration cleaning mode.
• Splashing of foam is suppressed.
• The battery capacity lamps blink in order.
• After about 20 seconds, it will be
automatically turned off, or you can turn
it off by pressing the power switch.
3
Remove the outer foil section
and clean with running water.
• See page 15 for attaching and
removing the outer foil section.
• Splashing is reduced by rinsing the
shaver in sonic vibration cleaning mode.
• After rinsing with water, shake the shaver up and down for a
few times to remove excess moisture and then wipe off any
drops of water with a dry cloth.
4
Attach the outer foil section
and dry with the self-cleaning
recharger.
1. Insert the shaver into the self‑
cleaning recharger and plug the
adaptor into a household outlet.
• Check that the charge status lamp
( ) is glowing.
2. Press twice.
The DRY lamp glows, and the “Dry/Charge” mode will start
after approximately 6 seconds.
• It is possible to change to the “AUTO” mode even after
the “Dry/Charge” mode has started.
Dry
180 min
Charge
0 to 60 min
3. Remove the adaptor after the selected mode is completed.
5
Lubricate the shaver.
It will keep the movement of the blade
smooth and maintain a comfort shave.
1. Apply one drop of oil to each of the
system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately ve seconds.
4. Switch off the shaver, and wipe off any excess oil from the
system outer foil with a soft cloth.
1
2
1