Operating Instructions

24
Problem Action
The cleaning liquid has
foamed.
If you mix soapy water or hand
soap with the detergent or use
another detergent, the cleaning
liquid will foam. Use the self‑
cleaning recharger after
thoroughly washing and drying
the shaver.
Replace the cleaning liquid.
(See page 21.)
Cleaning liquid has
accumulated in the
cleaning tray.
Remove any waste, etc. that
has accumulated in the drain at
the bottom of the cleaning tray.
(See page 21.)
If you use the self‑cleaning
recharger when the shaver is
wet or when soap or shaving
gel is on the shaver, cleaning
liquid may accumulate in the
cleaning tray.
Cleaning liquid leaked from
the cleaning liquid unit.
Do not press the cleaning liquid
unit removal button during any
mode.
Place the self‑cleaning
recharger horizontally.
If you use the self‑cleaning
recharger when the shaver is
wet or when soap or shaving
gel is on the shaver, cleaning
liquid may leak.
Problem Action
The cleaning liquid unit
cannot be removed.
Place the self‑cleaning recharger

(See page 14.)
The mode does not start.
Check that the AC adaptor is
connected to the self‑cleaning
recharger, and that the adaptor
is plugged in to a household
outlet. (See page 17.)

properly attached to the self‑
cleaning recharger.
(See page 17.)
The Clean or Dry function may
not operate under extreme low
temperatures (approximately
0 °C or lower).
Check if the STATUS lamp is
glowing. (See page 22.)
The shaver cannot be
charged.
Gently wipe the main body rear
terminals and the charging
terminals of the self‑cleaning
recharger with a cloth or tissue
dampened with water.