(Household) Operating Instructions Rechargeable Shaver Model No. ES‑LT71 Before operating this unit, please read these instructions completely and save them for future use.
Thank you for choosing a Panasonic shaver. With our WET/ DRY technology, you can enjoy using your Panasonic shaver dry or in the shower or bath for gentle and easy shaving. Please read all instructions before use. Important This shaver has a built-in rechargeable battery. Do not throw into fire, apply heat, or charge, use, or leave in a high temperature environment. Before use This WET/DRY shaver can be used for wet shaving with shaving lather or for dry shaving.
Storing the shaver • Store the shaver in a place with low humidity after use. • Do not store the shaver where it will be exposed to direct sunlight or other heat sources. • Disconnect the power cord when storing the shaver. • Do not bend the power cord or wrap it around the shaver. • Keep the oil away from children. Self-cleaning recharger • Do not clean the AC adaptor or the self-cleaning recharger in water as it will damage them or cause an electric shock.
Parts identification Lock the power switch: For when carrying the shaver. A Protective cap B Outer foil section 1 Foil frame 2 System outer foil 3 System outer foil release buttons C Inner blades D Main body 4 5 6 7 8 9 : ; Using the lock ring Use the lock ring to lock or unlock the power switch. 1. Rotate the lock ring until it clicks. Unlock the power switch: For when shaving, washing the shaver, lubricating the shaver.
Charge Charging with the self-cleaning recharger Thoroughly wipe off any drops of water on or around the selfcleaning recharger so that it is dry before charging the shaver. the appliance plug 1 Insert into the self-cleaning recharger. 2 Remove the protective cap and then attach the shaver. 3 Plug in the AC adaptor. Charging without the self-cleaning recharger You can also charge without the self-cleaning recharger. 1. Insert the appliance plug into the shaver. 2.
Shave Using the shaver Pivot action selector Use to select “SOFT” (soft) or “LOCK” (lock). You can change the pivot action whether the shaver is turned on or off. Using the trimmer the lock the shaver as 1 Rotate 2 Hold ring and press the illustrated above and power switch. shave. Page 4 • We recommend using the shaver in an ambient temperature range of 5 - 35 °C. If used outside this range, the appliance may stop operating. Start out shaving by applying gentle pressure to your face.
Care Cleaning with the self-cleaning recharger Preparing the self-cleaning recharger Remove the shaver and the appliance plug from the self-cleaning recharger. the water 1 Remove tank and then open 1 the water tank cap. 2 6 Attach the detergent cartridge. away the old 2 Wash cleaning liquid and • Replace the detergent cartridge when the status lamp is illuminated. • The expiration date of the cleaning liquid is 6 months after it is opened.
Course Cleaning the shaver Use the self-cleaning recharger in temperatures between 15 °C and 35 °C. 1 Charge Time required (guide) Charge 0 to 60 min the appliance plug 1 Insert into the self-cleaning recharger. 2 the protective 2 Remove cap and then attach the 3 2 Clean/Dry/ Charge Clean 10 min Dry 50 min (80 min*) Charge 0 to 60 min shaver. 3 Plug in the AC adaptor. • Remove any soap or water on the shaver if it has been washed with hand soap or any other detergent.
Follow the steps outlined below if the status lamp blinks or glows Blinks Glows Correctly set the detergent cartridge and then restart a course. Remove the shaver from the selfcleaning recharger and then check that the [CLEAN] lamp has gone out. (Be careful as the blade may be hot or wet.) Check that the water tank is correctly attached, the water tank cap is securely closed and the selfcleaning recharger is placed horizontally. If the status lamp goes out Continue a course.
Replacing the system outer foil and the inner blades Lubrication To maintain shaving comfort for a long time, it is recommended that the oil provided with the shaver is used. 1. 2. 3. 4. Switch off the shaver. Apply one drop of oil to each of the outer foils. Raise the trimmer and apply a drop of oil. Switch the shaver on, and run it for approximately five seconds. 5. Switch off the shaver, and wipe off any excess oil from the outer foils with a soft cloth.
Replacement parts Replacement parts are available at your dealer or Service Center. Replacement parts for ES‑LT71 System outer foil WES9087 Inner blades WES9068 Cleaning the self-cleaning recharger Beard trimmings may become attached to the cleaning tray of the self-cleaning recharger. Follow the steps below to remove them. We recommend doing this each time you change the detergent cartridge. 1. Be sure to remove the water tank and the 1 appliance plug from the self-cleaning recharger.
• Perform steps 1 to 4 and lift the battery, and then remove it. For environmental protection and recycling of materials This shaver contains a Lithium-ion battery. Please make sure that the battery is disposed of at an officially assigned location, if there is one in your country. Specifications Power source See the name plate on the AC adaptor. (Automatic voltage conversion) Motor voltage 3.6 V DC Charging time Approx. 1 hour This product is intended for household use only.
MEMO 15
Panasonic Electric Works Wanbao (Guangzhou) Co., Ltd. http://panasonic.
