Operating instructions

9
Charging without the charging stand
1. Press the power switch to turn off the power, and
insert the appliance plug into the clipper.
2. Plug in the adaptor into a household outlet.
AC operation
If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly
or stop, even with the AC operation. In this case, charge the
battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.
Using the clipper
• Make sure that the clipper is turned off.
• The appliance may not operate in an ambient temperature lower
than approximately 5 °C.
1
1
Set the trimming height.
2
2
Press the power switch to turn on the power.
Setting the trimming height
For a trimming height of 0.8 mm to
2.0 mm, turn the dial to the desired
height.
Use an attachment for a trimming
height higher than 3 mm or more.
Trimming
height
indicator
0.8
1.1
1.4
1.7
2.0
ER-GP81_UK.indb 9 2017/04/03 9:30:55