Operating instructions
13
Removing the built-in rechargeable battery
Remove the built-in rechargeable battery before disposing
the clipper.
Please make sure that the battery is disposed of at an ofcially
designated location if there is one.
This gure must only be used when disposing the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it may cause malfunction.
• Remove the clipper from the AC adaptor.
• Press the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
• Perform steps to and lift the battery, and then remove it.
• Take care not to short circuit the positive and negative terminals
of the removed battery, and insulate the terminals by applying
tape to them.
For environmental protection and recycling of materials
This clipper contains a Lithium‑ion battery.
Please make sure that the battery is disposed of at an ofcially
assigned location, if there is one in your country.
Specications
Power source
See the name plate on the AC adaptor.
(Automatic voltage conversion)
Motor voltage
3.6 V
Charging time Approx. 1 hour
ER-GP81_UK.indb 13 2017/04/03 9:30:56