Operating Instructions AC/Rechargeable Professional Hair Clipper Model No. ER1511 Before operating this unit, please read these instructions completely and save them for future use.
Thank you for choosing a Panasonic Hair Clipper. Please read all instructions before use. Important Before use This clipper is designed for professional use to trim hair and beards. Charge it for 8 hours before use for the first time in order to activate the built‑in rechargeable batteries. It can be operated on either an AC adaptor or rechargeable batteries. Read all instructions carefully before use. Charging the clipper • Do not use any power cord or AC adaptor other than this AC adaptor (RE9‑41).
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. • Never tamper with moving parts. • Avoid grabbing the clipper by the power cord, as it may become detached, causing damage or injury. • If the clipper is not working properly, have it inspected at an authorized service center.
Charge Charging the hair clipper the power cord to the 1 Connect charging stand. the power switch to 2 Slide “0·CHARGE”. in the AC adaptor into a 3 Plug household outlet and place the clipper on the charging stand. • Charge status ( ) lamp glows and charging starts. • Charging is completed when Charge status ( ) lamp blinks. (Max. 1 hour later) • 1 full charge will provide approximately 70 minutes of continuous operation.
About the LED display While charging After charging is completed 10 minutes after charging is completed HIGH MID LOW HIGH MID LOW HIGH MID LOW glows. • “HIGH”, “MID” or “LOW” blinks. blinks once every second. blinks once every 2 seconds. • “HIGH/MID/LOW” go out. While using HIGH MID LOW “HIGH” blinks - The battery capacity is enough. “MID” blinks - The battery capacity is approx. 60% or less. “LOW” blinks - The battery capacity is approx. 10% or less.
Cut Using the hair clipper Turn the dial clockwise or counterclockwise to adjust the moving blade back and forth to get the desired height. Adjustable in 5 stages from 0.8 mm to 2.0 mm in 0.3 mm steps without attachments. The actual cut length may be longer than the set length. Using the comb attachments 1. Select the trimming heights indicated on the insides and sides of the attachments. 2 Set the dial to “0.8” and then mount the attachment to the clipper as illustrated. 0.
Care Blade maintenance Removing and mounting the blade Removing the blade 1. Hold the clipper with the switch facing upward and push the blade with your thumb while catching the blade in your other hand. • Be sure to turn off the power before you remove the blade. Mounting the blade 1. Set the dial to “2.0”. 2.0 2. Fit the mounting hook into the blade mounting on the clipper and push in until it clicks.
Cleaning the blade 1. Brush off any hairs from the clipper and from around the blade. 2. Remove the 3. Brush the hairs out from blade and brush between the stationary off the hairs blade and the moving blade from the blade while pressing down on the edge. cleaning lever to raise the moving blade. Lubrication 1. Apply a few drops of the oil to the space between the stationary blade and moving blade. • Apply the oil to the clipper before and after each use. 2. Set the dial to “2.
Removing the built‑in rechargeable batteries 1. Remove the blades 1 and four screws 2. 2. Remove the spring 3, the under cover 4, and the blade holder 5. 3. Remove the dial 6 and open the housing 7, and then take out two batteries 8. • Disconnect the clipper from a household outlet. • Discharge the batteries completely before removing them. • Be careful not to short-circuit the batteries. WARNING - Do not attempt to replace the batteries for the purpose of reusing the clipper.
Panasonic Electric Works Co., Ltd. http://panasonic.
