User Manual

10
English
Cleaning
Wet cleaning
1. Wet the outer blade with water, and
apply some hand soap and some water
to the outer foil.
2. Slide the power switch to the “O”
position, and let it foam for
approximately 10 seconds.
3. Turn off the power.
▼ ▼
To clean lightly dirty parts To clean heavily dirty parts
• Quick cleaning
4. Open the water inlet (see
page 12) and turn on the
power again.
• If the trimmings box is
removed, open the water
inlet after attaching the
trimmings box (see page 14).
5. Pour water through the
water inlet at the “
”
above the “
” mark, rinse
well and slide the power
switch to the “I” position.
• Complete cleaning
4. Slide the power switch to
the “I” position.
5. Remove the blades and
the trimmings box (see
pages 12 and 14) and rinse
under running water.
• Cover the drainage outlet of
washbasin to prevent the
inner blade from owing
away.
▼ ▼
6. Wipe off water with a towel or
similar item, and let it dry naturally.
• It will dry faster with the blades and
the trimmings box removed (see
pages 12 and 14).
PB016722 - ER-GN70������_(01GB)_07-30-18.indd 10 2018/7/30 16:29:42