Household Massage Lounger Sillón de Masaje Doméstico Operating Instructions Instrucciones de Uso Model No./Nº de Modelo EP30007 Before operating this unit, please read these instructions completely. Antes de utilizar esta unidad, lea compleatamente estas instrucciones y guárdelas para referencia futura.
INDEX English See pages 1–48 ÍNDICE Español Consulte las páginas S1–S48
IMPORTANT SAFETY INSTRUCTIONS Basic precautions should always be followed when using an electrical unit, including the following. Please ensure that you read all instructions before using the Household Massage Lounger. DANGER – To reduce the risk of electric shock: 1. Always unplug this unit from the electrical outlet immediately after using and before cleaning. WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons: 1. 2. 3. 4. 5. 6. 7.
SAFETY PRECAUTIONS CAUTION: To avoid the risk of injury: 1. Persons with any of the conditions listed below or who are undergoing medical treatment or suffer from medical conditions should consult with their physicians before using the unit: a) Pregnant women, people who are ill, in poor physical shape. b) People suffering from back, neck, shoulder, or hip pain. c) People who have a pacemaker, defibrillator, or other personal medical devices prone to electronic interference.
OPERATING PRECAUTIONS WARNING: To avoid damaging the chair, follow these precautions: 1. The chair is designed for a maximum user weight of 264 lbs (120 kg). Exceeding the maximum weight may cause permanent damage to the massage mechanism and/or other components of the unit. Any such damage is deemed to be user abuse and is not covered under the Limited Warranty. 2. Do not sit on or drop the control panel. Do not pull the control panel cord or the power cord.
GROUNDING INSTRUCTIONS This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
Part names and functions Main unit Front 1 3 4 5 6 7 8 9 2 10 1 Legrest 11 12 13 5 Seat/Thigh Side Massage section 2 Leg/Sole massage section • Includes air massage function 14 12 Hand/Arm massage section • Includes integrated air massage function 13 Control Panel Stand Covers • On both the left and right sides Seat/Thigh Soft Massage Plates (integrated) 14 Outer Shoulder massage section • Includes integrated air massage function • Position adjustment possible Sole Reflexology Plates • Rem
Back 15 19 15 Back Cover 16 Control Panel Holder 20 21 22 16 17 18 13 23 23 Power Supply Box Lock Switch Power Switch 17 Child Safety Decal 18 Control Panel Stand 19 Power Plug 20 Power Cord 21 Safety Precaution Label 22 Wheels Lock Switch Key Lock Switch Key Tag • For preventing children from swallowing it by accident
Control Panel Cover closed 13 Cover open 14 15 1 Off/On 2 Quick Stop • Press this button to stop the massage immediately. 3 User Memory • See page 39 to 41 4 Program Selection • See page 18 5 Ottoman Angle Adjustment • See page 35 6 Reclining Angle Adjustment • See page 35 7 Display • This illustration simulates when all lights are illuminated. • See page 8 17 16 8 Voice Guidance Volume • See page 37 14 Stretch • See page 34 9 Ultra Knead • “Ultra Knead” is the name of the massage actions.
Display * This illustration simulates when all lights are illuminated.
Setting up the massage lounger to use the unit 1 Where Ensure there is adequate space to recline. Keep at least 4" (10 cm) away from the wall. Caution Approx. 77" (195 cm) • Do not use the unit in areas with high humidity, such as the bathroom, because this can lead to electric shock or other accidents. • Place the unit on a totally flat surface. Failure to do so may result in the unit tipping over. Width approx. 33" (84 cm) Approx. 12" (30 cm) Approx.
Confirm that the main unit and the accessories are in the box. Main unit Width: Approx. 27" (68 cm) Height: Approx. 26" (66 cm) Length: Approx. 63" (160 cm) Accessories • Control Panel Stand • Pillow • Armrests (Right/Left) Control panel holder Fixing screw Left/Right indication Clip • Control Panel Stand Covers Air plug Small holes on the inside fabric are an intentional part of the functional design. • Sole Reflexology Plates • Allen Key — 1 (Cross-section) 0.
Assembly 1 Attaching the Groove Armrest armrests (On both the right and left sides) 1. Insert the armrest into the unit. • Be careful to avoid pinching your fingers. (1) Align the position Right/Left indication (2) Fasten the armrest with the attachment screws. Main unit Pipe 2. Fasten the armrest with the Attachment attachment screws. Screw Set the two attachment screws in place by hand first and then tighten firmly with the allen key. Attachment Screw Turn screws clockwise to tighten.
the control panel stand to the right or left side panel of the unit 3 Attaching (Diagram shows attachment to right armrest.) 1. Insert the attachment screw into the lower hole first and then tighten lightly by hand. The position of the control panel when seated can be selected by choosing the appropriate hole for the screw. 2. Securing the stand with the attachment screws. Tighten the two screws for the remaining two holes lightly by hand and then tighten firmly with the allen key. Near Approx.
When removing the control panel stand cover 1. Insert the head of a flat-tip screwdriver in the gap under the mark (O). Gap 2. Push the bottom tab of the cover up to lift the cover. 3. Perform the same procedures as 1 and 2 above for the other gap. 4. Pull the cover up diagonally. 2 • Performing this procedure with the allen key or a Phillips screwdriver could damage the unit. 1 2 5 Raising the backrest to the upright position 1. Insert the power plug into the power outlet. 2.
Moving the control panel cord to the left side (when control panel stand is on left side) 1. Press the 2. Press the Legrest button on the control panel to turn on the power. button on the control panel and hold until the legrest has risen far as it will go. Continue pressing until a “beep-beep-beep” sound is heard. 3. Remove the control panel cord from the cord-holder groove. 4. Move the control panel cord under the legrest to the left side. 5.
2. Fasten the control panel cord using the clip. Lift the control panel to remove. Clip Fasten the cord so that the Control panel cord portion under the clip is not slack. 7 Inserting the shoulder plate 1. Insert the plate into the pocket on the outer shoulder massage unit. • Grasp the pocket and pull it slightly to expand the opening, so that the plate can be inserted easily. 2. Slide the inserted plate for the outer shoulder to the inside (recommended position).
Before sitting down Check the following before using the unit the surrounding area 1 Check Make sure there are no objects, people, or pets in the vicinity of the unit. 2 Check the power cord and the power plug Warning • Remove dust from the power plug periodically. Failure to observe this precaution may result in defective insulation of the cord due to moisture. Clean dust from the cord using a dry cloth. • Do not damage the power cord and the power plug.
2. Make sure there is no foreign objects on the chair. Outer shoulder massage section Caution • Sit on the unit after confirming there is no foreign matter between the parts of the unit. (Check for foreign objects on the backrest, leg/sole massage section, hand/arm massage section, seat/thigh side massage section, or the outer shoulder massage section.) Failure to observe this precaution may result in accident or injury.
Program Massages Pre-Program Quick Massage the button to turn on the power. 1 Press • The power will turn off automatically if the massage does not start within 3 minutes after turning on the power. 2 Press one of the flashing buttons ( ) to select the program. Pre-Program and Quick Massage Characteristics (Upper Body) • See page 21 for an overview of the respective programs. SHIATSU: Uses mainly shiatsu massage to loosen up deep-seated knots of tension.
1. Body scanning will commence when the program is selected. The body scanning will properly detect height ranges between approximately 4'7" and 6'8" (140 and 185 cm). The unit will automatically recline to the correct measuring position. Sit as far back in the seat as possible with your head on the pillow. Reclined approx. 12˚ Correct Massage Position 1 2 3 4 1 2 3 4 Adjust the pillow height so that the bottom edge of the pillow is at ear level. See page 38. Raised approx.
When the massage starts Adjust the length of the legrest to accommodate the position of the backs of your calves or knees to fit into the legrest wells. For the hand/arm massage, lift the armrest up and insert your arm. Armrest Insert your hand with fingers extended. Push the legrest with the sole of your foot while pulling the legrest slide lever. Caution • Remove hard objects, such as false fingernails, wristwatches, or rings when massaging the hands or arms.
Overview of the Pre-Program and Quick Massage (Upper Body) Shiatsu Program (I) 1) Ultra knead/ 2) Ultra knead/ 3) Ultra knead/ 4) Ultra knead/ 5) Ultra knead/ 6) Ultra knead/ 7) Finishing Shiatsu/Grasp Shiatsu on Back/ Shiatsu/Grasp Shiatsu on Back/ Shiatsu/Grasp Kneading on Touches on Neck/Shoulder Lower back on Neck/Shoulder Lower back on Neck/Shoulder Back/Lower back Deep Program (II) 1) Ultra knead/ 2) Ultra knead/ 3) Ultra knead/ 4) Ultra knead/ 5) Ultra knead/ 6) Ultra knead/ Kneading/Grasp Kneading
Creating Self-Programs Self-Program Self-Program The Self-Program allows you to create a massage where you determine the time and intensity in neck, shoulders, back, and lower back by selecting from levels 0 (no massage) to 3 (longest and most intense). the button to turn on the power. 1 •Press The power will turn off automatically if no operation is executed for 3 minutes without performing massage. the right cover and press the button.
3 Set the time and intensity for the neck, shoulder, back, and lower back, respectively ( ). • The level shifts sequentially whenever the button is pressed. Display How to shift the level • Press the button to shift the levels for “NECK,” “SHOULDER,” “MIDDLE,” and “LOWER” by one up/down at the same time. • 3 bars represents more time than one bar. • If all areas are 3 bars, then both time will be equally long and the massage will be strong in all areas.
Manual Selection Massages Manual Operation Manual Operation Manual Operation provides a massage of your favorite body part with your favorite action by selecting neck, shoulder, back, or lower back and an action. the button to turn on the power. 1 Press • The power will turn off automatically if no operation is executed for 3 minutes without performing massage. 2 Open the right cover and press the button. The manual setting display on the top right of the display will flash.
3 Select the location you want to massage ( • You can select an action combined with “FULL ROLL” by pressing the ). button. Display 4 Select the massage action ( ). By pushing on the body part again, the massage action will toggle down from ultra knead to tap. Shoulder massage will toggle all the way to grasp. the button to start the action. 5 Press The massage will start after the body scanning. Body scanning for Manual Operation For the Neck/Shoulder: Normal body scanning.
Description of Massage action (The figures are images of the respective operations.) ULTRA KNEAD Kneading action at small points. SHIATSU Action compressing muscle knots vertically. KNEAD Deep kneading action. SWEDISH Action of rubbing gently across a wide area. STRETCH Slow stretching action. TAP Tapping action for right and left alternately. GRASP Action like grasping the shoulder. FULL ROLL Action stretching the body along the backbone.
Adjustments During a Massage ULTRA KNEAD REPEAT BACK INTENSITY POSITION STYLE SPEED Changing the program Only for the Pre-Program, Quick Massage, and Self-Program Display Ultra knead function • When the button is pressed, the Ultra knead action will be repeated on that point for a certain period. For details of the Ultra knead action, see page 26. This will be turned on when the action is repeated. Repeat function • The action at the time when the button is pressed will be repeated.
Adjusting the intensity The intensity may not change immediately if the button is pressed in the middle of an action. Display For the Pre-Program, Quick Massage, and Self-Program • The intensity can be adjusted in 3 steps. Light For Manual Operation • Adjustment is possible until a “beep-beep-beep” sound indicating the limit point is heard. The adjustable range varies with the actions and body parts.
Details about the massage style • Massage head movement is firm with only the upper massage heads moving so that they act like two thumbs. This is shiatsu style massage of acupoints. Thumb-like action Approx. 20˚ • The massage heads remain spread apart, forming a palm which gently presses against the back. There is a gentle 20 degree pivot, which softens the massage feel. Palm-like action Approx. 20˚ • Upper and lower massage heads pull together to form a “fist”, which presses softly on the back.
Air Massage Adjustments Air Massage • When a pre-program and quick massage are selected, the air massage Seat/Thigh for arm, seat, shoulder, leg/foot are all automatically turned on. • When Self-Program and Manual Operation are selected, the air massage for all parts is turned off. Outer shoulder 1 Open the left cover. 2 Press the , each off or on.
Adjusting the Legrest length Adjust the legrest so that your feet fit snugly. For a person who is smaller: • If the legrest is raised up, the fit with your leg and sole of your foot will be better. Press the button. For a person who is tall: • Push the legrest out by pulling back on the legrest slide lever. • Tall people will have a better fit by lowering the legrest somewhat. Press the button. Pull the legrest slide lever. Push with the soles of your feet to slide the legrest out.
Arm Massage Caution • Remove hard objects, such as false fingernails, wristwatches, or rings when massaging the hands or arms. Failure to do so may result in injury. Position the forearm and hand at the center of the armrest. Insert the hand all the way inside. Center of the armrest • Raise the backrest if any difficulty is experienced when positioning the hand and forearm. How to use the hand/arm massage 1. Lift the hand/arm massage section up. 2. Insert the hand with fingers extended.
Outer Shoulder Massage The outer shoulder massage provides reflexology on muscles knots on the outer side of the shoulder blades. The outer shoulder section of the backrest unit moves inward using air pressure to gently massage these muscles. Target area for massage between armpits and shoulder blades on the outside of the shoulder. Adjustments for the Shoulder Massage Problem Solution Adjust the position of the plate until it feels right.
