Datasheet

CLASSIFICATION
PRODUCT SPECIFICATION
No.
DS-1740-2400-102
REV.
1.2
SUBJECT
CLASS 2 BLUETOOTH LOW ENERGY
SINGLE MODE MODULE
PAGE
22 of 34
CUSTOMER’S CODE
PAN1740
PANASONIC’S CODE
ENW89846A1KF
DATE
22.04.2014
PANASONIC INDUSTRIAL DEVICES EUROPE GMBH
www.pideu.panasonic.de
20 INSTALLATION NOTES
(1) Reflow soldering is possible twice based on the conditions in chapter 15.
Set up the temperature at the soldering portion of this product according to this
reflow profile.
(2) Carefully position the products so that their heat will not burn into printed circuit
boards or affect the other components that are susceptible to heat.
(3) Carefully locate these products so that their temperatures will not increase due to
the effects of heat generated by neighboring components.
(4) If a vinyl-covered wire comes into contact with the products, then the cover will
melt and generate toxic gas, damaging the insulation. Never allow contact
between the cover and these products to occur.
(5) This product should not be mechanically stressed or vibrated when reflowed.
(6) If you want to repair your board by hand soldering, please keep the conditions of
this chapter.
(7) Do not wash this product.
(8) Refer to the recommended pattern when designing a board.
(9) Pressing on parts of the metal cover or fastening objects to the metal will cause
damage to the unit.
(10) For more details on LGA (Land Grid Arrey) soldering processes refer to the
application note.
21 USAGE CONDITIONS NOTES
(1) Take measures to protect the unit against static electricity.
If pulses or other transient loads (a large load applied in a short time) are applied
to the products, check and evaluate their operation befor assembly on the final
products.
(2) Do not use dropped products.
(3) Do not touch, damage or soil the pins.
(4) Follow the recommended condition ratings about the power supply applied to this
product.
(5) Electrode peeling strength: Do not add pressure of more than 4.9N when
soldered on PCB.
(6) Pressing on parts of the metal cover or fastening objects to the metal cover will
cause damage.
(7) These products are intended for general purpose and standard use in general
electronic equipment, such as home appliances, office equipment, information
and communication equipment.