Datasheet

Product Specification
TS-UQ-EM-73
EETUQ2G271KF
1
P a n a s o n i c C o r p o r a t i o n
Design, Specifications are subject to change without notice. Contact your nearest Panasonic sales office for the latest specifications prior
to purchase and/or use. Whenever any doubt about safety comes up with this product please contact us immediately for engineering
assistance without fail. Specifications are typical and may not apply to all applications.
[Specification]
Customer Part No.
Product Part No.
EETUQ2G271KF
General
Specification
Unless specification otherwise, the
product shall conform to JIS-C-5101-4-1
Category temp.
range
-25˚C ~ +85˚C
Item
Specification
Measurement Condition
Nominal Cap.
270 µF
frequency : 120Hz; temperature : +20˚C
Cap. Tolerance
-20 ~ +20 %
frequency : 120Hz; temperature : +20˚C
Rated Working Volt.
400 V.DC
Surge Voltage
450 V.DC
Leakage Current
0.98 mA max
After 5 minutes application of rated
working voltage at +20˚C
D.F. (tan δ)
0.15 max
frequency : 120Hz; temperature : +20˚C
Ripple Current
1.67 A
rms
frequency : 120Hz;
temperature : +85˚C
Endurance
The capacitor shall be subjected to application of the D.C. voltage with full rated
ripple current at the upper category temperature for a period of 2000 hours. After
stabilizing at room temperature (+15 ˚C to +35˚C), the capacitor shall not exceed
the specified limits. (The sum of DC voltage and ripple peak voltage shall not exceed
the rated working voltage)
Capacitance Change : Within ± 20% of initial measured value
D.F. (tan δ) : Less than 200% of the initial limit
DC Leakage Current : Less than the initial limit
Shelf Life
The capacitor shall be stored at +85˚C for 1000 hours with no voltage applied. After
stabilizing at room temperature (+15 ˚C to +35˚C), the capacitor shall be subjected
to rated voltage for 30 minutes. The capacitor shall not exceed the limits specified
in the Endurance section.
[Dimension]
(mm)
φD
30
L
25
* With top plate.
** Marking are printed on the sleeve.
*** When Capacitors of φ35×50L are mounted on PWB reinforce them with mounting clamp or adhesives. (Avoid
using adhesives including halogenated compositions.)
PC Board Mounting Holes
Terminal
4.0±0.5
Vent
(10.0)
4.0±0.5
1.5±0.2
Polarity Bar
L+2max.
(φD)
φD+1.0max.
2-φ2.0±0.1
(t=0.8)
Top of spin
2.0max.
P.V.C. sleeve
10.0±0.1
(3.5)
0.8
+0.2
-0.1