Datasheet

Product Specification
EGC-RF-1-0
Electric Double Layer Capacitor RF series
14
19.Heat at curing adhesives for chip components
A
pplying high temperature to Gold Capacitor for a long time may cause poor reliability, even cause initial failure.
Therefore, heat at curing adhesives should be low temperature and short time. Allowable condition is as follows. For
coin type (EL) and multi-layer type (SG, SD, NF, F, SE) of Gold Capacitor, surface temperature should be 100°C
within 60sec. (In this case, peak temperature should be less than105°C)
The application guidelines above are taken from:
Technical report EIAJ RCR-2370 issued by the Japan Electric Industry Association, Inc. “Guideline of notable for
fixed electric double layer capacitors with non-solid electrolyte for use in electric equipment.”
For further details, please refer to this Technical Report.
Panasonic Electronic Devices Co.,Ltd.
105°C max.
100°C
Within 60sec
Gold Capacitor surface temperature (°C)