Operating Instructions

Preparation
22
1
Both earphones should be placed temporarily in the charging cradle for 10 seconds.
2
Remove them from the cradle and within 5 seconds while the earphone LED lights
(blue), touch and hold the sensor (L or R) for 7 seconds until the LED starts flashing
Red/Blue.
• The earphone LEDs light (Red/blue) indicates that the unit is in pairing mode.
3
Do Steps 2 to 3 of “Pairing procedure - When pairing your earphones first time with a
Bluetooth
®
device” (l 21).
4
Confirm that the earphones and the Bluetooth
®
device are connected.
Note
• You can pair a maximum of 10 Bluetooth
®
devices with the earphones. When you pair a device after the maximum
has been exceeded, previous devices are overwritten. To use overwritten devices again, do the pairing again.
• It is easier to pair if you disable the Bluetooth
®
function of the first device when pairing with a device after the first.
• When pairing with a device after the first time, if the connection with the device does not complete within 5 minutes,
the pairing mode on the earphones cancels and they transition to connection standby mode. Perform pairing again.
• This unit remembers the device lastly connected. The unit may connect automatically after turning on the power of
this unit.
• The unit can connect to a maximum of two Bluetooth
®
devices at the same time. (l 27, “Creating multi-point
connections”)
Connecting 2nd Bluetooth
®
device
eahaz60az40pnqp1654yafullengs.book22ページ２０２１年１２月２１日 火曜日 午後５時１８分