Operating Instructions

3.5 Programming the unit from the operation panel
Important
• For feature availability and selection information for your unit, print the "SETUP LIST" (page 133).
Features listed are available for your unit.
Programming features are as follows:
– "3.6 Programming features: Basic" (page 49)
– "5.4 Programming features: PC print" (page 77)
– "5.5 Programming features: USB print features" (page 78)
– "6.4 Programming features: Scan" (page 85)
– "7.4 Programming features: Copy" (page 103)
– "8.9 Programming features: Fax" (page 122)
– "9.2 Programming features: LAN" (page 127)
– "9.3 Programming features: Update" (page 130)
To change the feature settings
1.
/MENU
2.
Press and the 3-digit code.
3.
: Select the desired setting.
• This step will vary depending on the programming feature.
4.
: OK/SET / : "OK"
• This step will vary depending on the programming feature.
5.
: Press /MENU to exit.
: Press to exit.
Direct command for default setting (2-line LCD models only) ( )
• To change back to the default setting, press the specified number using the dial keypad in step 3 (not available
for some programs). If you want to reset all features, activate feature #159 (page 51).
3.6 Programming features: Basic
Feature Code Description
Default
key
Date and time #101 Enter the date and time (see page 59 for character entry). –
Your logo #102 Enter your logo (see page 59 for character entry). –
Your fax number #103 Enter your fax number (see page 59 for character entry).
For 2-line LCD models ( ):
• To enter a "+", press /Tone .
• To enter a space, press .
• To enter a hyphen, press R/FLASH .
• To erase a number, press
/STOP .
–
Language #110 The display and reports will be in the selected language.
FOR ENGLISH USERS:
If you want to change the language setting to English, proceed
as follows.
1. /MENU 1 1 0
2. Select English. OK/SET
*1
*1
For 2-line LCD models only. ( )
–
Location #114 This setting must match your location. –
3.5 Programming the unit from the operation panel
Operating Instructions 49