Operating Instructions

• If the unit enters standby mode during the
process, repeat from step 1 (the PIN code will
be renewed).
*1
For 2-line LCD models only. ( )
2.6.3 WPS incompatible access point
Important
• Make sure the LAN mode setting is set to
"WIRELESS" beforehand (feature #580).
• The following setting information for your
wireless access point is required:
– Network name (SSID)
– Network key (WEP / WPA key)
*1
– Connection type
– Network authentication type
– Data encryption type
• If your wireless access point is configured
to not show the network name (SSID), enter
the network name (SSID) manually (feature
#585).
*1 If your wireless access point is equipped
with several network keys, use only the
first network key (this unit is equipped
with a single network key).
1. /MENU 5 8 4 OK/SET
*1
2. Select the desired network name (SSID).
OK/SET
*1
• Depending on the settings for your wireless
access point, it may be necessary to select
WEP64 or WEP128. Select the desired item,
and then press OK/SET
*1
.
3. Enter the network key. : OK/SET /
: "OK"
• Depending on the settings for your wireless
access point, this step can be omitted if
encryption is not used.
• The LED blinks while connecting. When the
connection is complete, the LED stops
blinking and turns on.
*1
For 2-line LCD models only. (
)
Setting up your wireless access point manually
1. /MENU 5 8 5 OK/SET
*1
2. Enter the network name (SSID). :
OK/SET
/ : "OK"
3. Select the desired connection type.
OK/SET
*1
4. Select the desired network authentication type.
OK/SET
*1
5. Select the desired data encryption type.
OK/SET
*1
6. Enter the network key.
: OK/SET /
: "OK"
• Depending on the settings for your wireless
access point, this step can be omitted if
encryption is not used.
• The LED blinks while connecting. When the
connection is complete, the LED stops
blinking and turns on.
*1
For 2-line LCD models only. (
)
2.6.4 Setting up using Windows
®
Installer
If you use a Windows computer, it is possible to
configure wireless LAN settings during the
installation of Multi-Function Station. For details, see
“2.8 Installing software (including printer, scanner
and other drivers)” (page 33).
2.7 Required computer
environment
Important
• When using Windows Server
®
2008/
Windows Server 2012, only the printer driver
can be supported. Install the printer driver
using the Add Printer feature of Windows.
• With Mac OS X, only the printer driver,
scanner driver (TWAIN/ICA) and PC fax
(transmission) are supported. See the setup
guide for Mac OS X for details.
To use Multi-Function Station on your computer, the
following are required:
Operating System:
Windows XP/Windows Vista/Windows 7/Windows 8/
Windows 10
CPU:
Complies with Operating System recommendations
RAM:
Complies with Operating System recommendations
Other Hardware:
CD-ROM drive
Hard disk drive with at least 600 MB of available
space
Web browser (recommendation):
Windows Internet Explorer
®
8/9
Windows Internet Explorer 10/11 (with compatible
mode recommended)
Microsoft
®
Edge
2.6.3 WPS incompatible access point
32 Operating Instructions