Operating Instructions

7.3.11 Sorting copies by rotation
You can sort output into sets of documents (collated) or into sets of pages (uncollated).
Important
• Make sure of the following when setting recording paper into trays:
– Recording paper should set in portrait orientation for one paper tray, and in landscape orientation
for another paper tray.
– The paper set in each tray for this feature should be the same paper size and type.
1.
: /PAGE LAYOUT (repeatedly): "ROTATE SORT"
: Display "Settings" screen (page 86). "ROTATE SORT"
2. Select "ON". : OK/SET / :
Note
• Supported paper sizes are A4, Letter, B5(ISO)
*1
, B5(JIS)
*1
and 16K
*1
.
*1 Not supported duplex printing.
Collated pages
3
2
1
3
2
1
2
1
3
3
2
1
Uncollated pages
3
2
1
2
2
2
3
1
1
1
3
3
7.3.12 To make copies with "A3", "11 × 17", "8K", or "B4" documents (scanner glass only)
Important
• Make sure that the paper size of the multi-purpose tray (feature #381) is set to the same as the
document size beforehand.
1. Set the document as described below.
• Make sure to align the document with the corner where the mark is located.
2. Select the size of the original and "#2" for input tray from the copy size settings.
3. If necessary, change the resolution and contrast according to the type of document.
• To select the contrast, see page 87.
• To select the resolution, see page 87.
4. If necessary, enter the number of copies (up to 99).
5. Press
/START to scan the upper half.
6. Rotate the document 180 degrees to scan the bottom half.
7.3.11 Sorting copies by rotation
100 Operating Instructions