Operating Instructions

9
Chapter 1 Problem Solving
Code Check Points
J00 Sheet Bypass (Remove the misfed paper and load the paper again.)
J01 Paper Tray 1 & Paper Feed Section (Paper Tray 1-4 & Sheet Bypass) (See page 10)
J02 Paper Tray 2 & Paper Feed Section (Paper Tray 2) (See page 16)
J03 Paper Tray 3 & Paper Feed Section (Paper Tray 2-4) (See pages 16 to 17)
J04 Paper Tray 4 & Paper Feed Section (Paper Tray 3, 4) (See page 17)
J06, J26 Paper Feed Section (Paper Tray 1-4 & Sheet Bypass) (See pages 10, 16, and 17)
J07, J08,
J09, J27,
J28
Paper Feed Section (Paper Tray 2 & Optional Paper Tray 3 & 4) (See pages 16 to 17)
J16, J18,
J33-J35
Paper Feed Section (Paper Tray 1-4 & Sheet Bypass)
Verify that the media type selection in the Control Panel matches the media loaded on the Trays.
Ex: Select “Transparency” when Transparencies are loaded in the Sheet Bypass. (See pages 10, 16,
and 17)
J19 Paper Feed Section & ADU Section (See pages 10, 12, 16, and 17)
J82, J83,
J88
ADU Section & Fuser/Exit Section (See pages 12 to 13)
J30-J32,
J38-J40,
J42-J45
Paper Feed Section & Fuser/Exit Section (See pages 10, 13, 16, and 17)
J41, J50,
J51, J52,
J86
Fuser/Exit Section & Paper Transport Section (See pages 13 to 15)
J80, J81,
J87
Fuser/Exit Section (See page 13)
J54-J56 Paper Transport Section (See page 15)
J60-J66 Optional Finisher Section (See pages 18 to 19)
J70-J79,
J92-J94
ADF Section (See pages 21 to 22)