Operating Instructions User Authentication

28
Chapter 4 Appendix
29
Chapter 4 Appendix
Administrator Name & Password
The user name, and password for the system administrator are established in "Authentication Setting" on page
13 when User Authentication is enabled for the rst time. Use the following procedure if you subsequently wish
to change the system administrator name, or password.
Press the Function key.
Select "General Settings".
Select "60 - 79" tab, and then scroll the screen,
and choose "73 Administrator Name".
Select "09 Key Operator Mode".
3
Enter the Key Operator's password (8-digit),
and then choose "OK" .
Default password is "00000000".
To change this password, select “85 Key Operator
Password” in the General Setting (For Key Operator),
and then re-enter the new password.
Note: