Operating Instructions

4
Before executing the procedures
described below, make sure the Print
On Line LED is lit.
1
Press the Function key.
2
Select "General Settings".
3
Select "09 Key Operator Mode".
4
Enter the Key Operator's Password
(8 digits), and then select "OK".
5
1
2
Follow the procedure below if your network is not configured with the DHCP server, and the TCP/IP parameters must be
setup manually.
- IP Address
- Subnet Mask
- Default Gateway
- DNS Server
1
2
● Default password is "00000000".
To change this password, open "85 Key
Operator Password" in the General
Setting (For Key Operator), and then re-
enter the new password.
Function key
Print On Line LED
● Please wait until the Print On Line LED is
ON before pressing the Function key.
Select "04 Network Settings".
Setting up the Network Configuration
Network Configuration
02_07.pmd 10/11/2006, 08:504