Operating instructions

10
VIDEO
S VIDEO
COMPONENT VIDEO OUT
LNB
IN
Y
B
LNB
OUT
AV1(TV)
AV2 (EXT)
OPTICAL
OUT
DIGITAL
AUDIO
(PCM/BITST EAM)
AV OUT
OUT
AV
4
IN
AC IN
AV IN
AA
3
3
1
2
Connections
Before connection, turn off
all equipment and read
the appropriate operating
instructions.
Connection with Scart cable
For this optimum connection type, you will need a fully wired 21-pin Scart cable (not
provided).
After completing the above connections, the DVD Recorder proceeds with the
Automatic Setup. 18
Connect the satellite dish to LNB IN of the DVD Recorder.
Connect the AV1(TV) terminal (21-pin Scart socket) of the DVD Recorder to the
Scart input of the television.
Connect the DVD Recorder and the television to the power supply system.
1
2
3
Conditional Access module: The size of the Scart terminal prevents the Conditional
Access module from being inserted in the slot afterwards. Insert the module before
completing the above connections. 20
Select one of the described connection types A-E.
If your TV set supports RGB, in the Setup menu,
adjust the AV1 Output to [RGB 1] or [RGB 2]. 65
Rear panel television
AC mains lead
21-pin Scart cable (fully wired)
Antenna cable
(not provided)
AC mains supply
(AC 220 V - 240 V, 50 Hz)
AC mains lead
Slot for Conditional
Access module
Rear panel DVD Recorder
For TV sets supporting the Q Link
Direct TV Recording
TV/DVD automatic switch on: Both units are automatically switched on with PLAY, DIRECT NAVIGATOR, GUIDE
or PROG/CHECK.
If your TV set is in standby mode, it is switched on automatically with FUNCTION MENU, PLAY or on inserting a disc
(not with DVD-RAM, DVD-R, DVD-RW (DVD-Video format) and +R).
DVD automatic switch off: If you switch your TV set off, the DVD Recorder will also be switched off if it is in the STOP
mode.
You can also program Timer Recordings using your TV set. 46
(Registered trademark of Panasonic)
COMMON
INTERFACE
Necessary for TV with Q Link