Operating Instructions

Getting started
VQT3C13
15
5 Press [BACK/RETURN ].
6 Enter the new PIN.
≥The default PIN is “0000”.
1 Select the number, then press [1] (right).
2 Repeat step 1.
≥Make a note of PIN in case you forget it.
3 Press [OK] twice.
7 Set “Power Save” to “On”, “On Timer”
or “Off”, then press [OK].
≥Power consumption is lowered additionally
when “RF OUT ( Aerial Signal )” is set to “Off”.
(> 102)
≥Video from AV2 input cannot be viewed with
this unit in standby mode when Power Save in
Standby mode is activated.
When the following screen appears, Easy Setting
is complete.
≥Select “Yes” to proceed to “Network Easy Setting”.
(> 16)
≥Select “No” to finish the Easy Setting.
To stop partway
Press [BACK/RETURN ].
To restart set up
1 While stopped
Press [FUNCTION MENU].
2 Select “Setup” in “Others”, then press [OK].
3 Select “Auto Setup” in “Tuning”, then press [OK].
To display the Owner ID information on TV
1 While the unit is on, press and hold [OK], the
yellow button and the blue button on the remote
control at the same time for more than 5 seconds.
–“00 RET” is displayed on the unit’s display.
2 Repeatedly press [1] (right) on the remote control
or [Í/I] on the main unit until “01 OID” is displayed
on the unit’s display.
3 Press [OK] on the remote control or [< OPEN/
CLOSE] on the main unit.
The PIN is not displayed.
¾ To edit the Channel List (> 92, Channel List)
¾ To check the signal condition (> 93, Signal
Condition)
¾ To change PIN (> 102, PIN Entry)
¾ To sort the Channel List by region (> 92,
Channel Sorting by Region)
On It will go into the Power Save in
Standby mode.
On
Timer
Set the start and stop time and then
press [OK].
≥Power Save in Standby mode is
activated at the set time period.
Off It is possible to start quickly from the
standby mode. (Quick Start mode)
≥If you use Home Network ( DLNA )
Server function (> 101), select
“Off”. This function is not available
with other settings.
RETURN
Enter a new 4-digit PIN, then press OK.
This PIN will be used for controlling viewing and playback.
PIN will be set to “0000” by pressing “RETURN” when there is no
number input.
0
-
Number
9
PIN Entry
- - - -
Power Save in Standby
From To
Power Save
0 6
On
OK
Easy Setting
Easy Setting has been completed.
To use Internet functions, network connection needs
to be made first. Proceed Network Easy Setting ?
Select “Yes” to start. Select “No” to exit the Setup.
Yes No
DMRBWT800&700EB-VQT3C13_eng.book 15 ページ ２０１１年３月２４日 木曜日 午後２時４４分