User Guide

RQT8746
18
Control with HDMI (HDAVI Control
TM
)
HDAVI Control is a convenient function that offers linked operations of this unit, and a Panasonic television (VIERA) or amplifier/receiver under
HDAVI Control.You can use this function by connecting the equipment with the HDMI cable. See the operating instructions for connected
equipment for operational details.
≥It is recommended that you use Panasonic’s HDMI cable.
Recommended part number:
RP-CDHG15 (1.5 m), RP-CDHG30 (3.0 m),
RP-CDHG50 (5.0 m), etc.
≥Non-HDMI-compliant cables cannot be utilized.
≥After connecting the unit to a television using an HDMI cable,
set “Control with HDMI” to “On” (➡ 23).
≥Set the HDAVI Control operations on the connected equipment
(e.g., television).
≥Turn on all HDAVI Control compatible equipment, set the
television to standby mode and turn it on again, and then select
this unit’s input channel on the connected television so that the
HDAVI Control function works properly. Also when the
connection or settings are changed, repeat this procedure.
What is HDAVI Control?
Functions made possible with HDAVI Control are...
One touch play
You can turn on this unit, television and amplifier/receiver, and start playing the disc in the
play position with a single press of a button.
Press [ONE TOUCH PLAY].
≥When operating, point the remote control at the remote control
signal sensor on the main unit.
Automatic input switching
When the following operations are performed the television will automatically switch the input
channel and displays the corresponding action.
– When play starts on the unit
– When an action that uses the display screen is performed (e.g., Direct Navigator screen)
Power on link
When the television is off and the following operations are performed, the television will
automatically turn on and displays the corresponding action.
– When play starts on the unit
– When an action that uses the display screen is performed (e.g., Direct Navigator screen)
Power off link
All connected equipment compatible with HDAVI Control including this unit is automatically
set to standby mode when you set the television to standby mode.
≥This unit is automatically set to standby mode even during playback or any other operation.
≥Only this unit is set to standby mode when you press the standby/on button of the unit or
the remote control for shutting it down. Other connected equipment compatible with HDAVI
Control stays on.
≥When [ONE TOUCH PLAY] or
[1] (PLAY) is pressed on this unit
for “Automatic input switching” or
“Power on link”, the playback image
is not immediately displayed on the
screen and it may not be possible to
watch the contents from where
playback started.
In this case, press [:] or [6] to
go back to where playback started.
AV OUT
Please see page 8 (Connection C) or 9 (Connection D) for detailed
setup.
HDMI IN
HDMI AV OUT
This unit
HDAVI Control
compatible
television
HDMI OUT
HDMI IN
HDAVI Control
compatible
amplifier/receiver
ONE TOUCH
PLAY
NOTE
Playback 11 Control with HDMI (HDAVI Control
TM
)
DMP_BD10EG.book Page 18 Wednesday, August 30, 2006 8:57 PM