Operating instructions

VQT1N09

Advanced (Playback)

• It may not be possible to use the DPOF print settings with other equipment. In this case, cancel

all the settings, and reset the settings.

• If the file is not based on the DCF standard, the DPOF print setting cannot be set.

You can set protection for pictures you do not want to be deleted by mistake.

Select [PROTECT] on the [PLAYBACK] mode menu. (P19)

Press [‚] to return to the menu screen.

• Press [MENU/SET] to close the menu.

∫ Cancelling all the [PROTECT] settings

1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].

2 Press 3 to select [YES] and then press [MENU/SET].

3 Press [MENU/SET] to close the menu.

•

If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.

Note

•

The protect setting may not be effective on other equipment.

• Even if you protect pictures in the built-in memory or a card, they will be deleted if the built-in

memory or the card is formatted.

• Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they

cannot be deleted when the card’s Write-Protect switch is set to [LOCK].

P [PROTECT]

Press 3/4 to select [SINGLE] or [MULTI] and then

press [MENU/SET].

Select the picture, and then press

[MENU/SET].

When [MULTI] has been selected

•

Repeat these steps for each picture.

• The settings are cancelled when [MENU/

SET] is pressed again.

[SINGLE] [MULTI]

Press 2/1 to

select the picture.

Press 3/4/2/1

to select the

pictures.

VQT1N09_ENG.book 82 ページ２００７年１２月２６日　水曜日　午後６時５分