Operating Instructions

- 60 -
Recording
∫ Available Flash Settings in Recording Mode
The available flash settings depend on the Recording Mode.
(±: Available, —: Not available, ¥: Scene Mode initial setting)
¢ [ ] is displayed.
• The flash setting may change if the Recording Mode is changed. Set the flash setting again if
necessary.
• The flash setting is memorised even if the camera is turned off. However, the Scene Mode flash
setting is reset to the initial setting when the Scene Mode is changed.
• Flash will not be activated when recording motion picture.
∫ The available flash range
∫ Shutter speed for each flash setting
¢1 Varies according to the settings of [Min. Shtr Speed] and [Sensitivity].
¢2 When [Min. Shtr Speed] is set to [AUTO]. Varies according to the [Sensitivity] setting.
¢3 When [ ] in [Sensitivity] is set.
• ¢2, 3: The shutter speed becomes a maximum of 1 second in the following cases.
– When the Optical Image Stabiliser is set to [OFF].
– When the camera has determined that there is very little jitter when the Optical Image Stabiliser is
set to [ON].
• In Intelligent Auto Mode, shutter speed changes depending on the identified scene.
• In Scene Mode, shutter speed will be different from the above table.
‡ ‰ Œ
±
¢
———±
±±±±±
* + : ; ±¥±— ±
, / ï 5 ————¥
- ¥ — ± — ±
. ———¥±
1 í 9 ± — ± — ¥
¥±±— ±
Wide Tele
[AUTO] in
[Sensitivity]
60 cm (2.0 feet) to 4.1 m (13 feet) 1.5 m (4.9 feet) to 2.1 m (6.9 feet)
Flash setting Shutter speed (Sec.) Flash setting Shutter speed (Sec.)
‡
1/60
¢1
to 1/1600
1
¢1
to 1/1600
1 or 1/8 to 1/1600
¢2
1 or 1/4 to 1/1600
¢2, 3
‰Œ