User guide

Advanced (Recording pictures)
38
VQT1C60
If you use the flash when the ISO
sensitivity is set to [AUTO] or when the
highest ISO sensitivity is set to a setting
other than [ISO400] in intelligent ISO
sensitivity mode [ ] (P41), the ISO
sensitivity is automatically increased to a
maximum of [ISO640]. (It is a maximum of
[ISO400] in [BABY1]/[BABY2] (P46) and
[PET] (P47) in scene mode.)
If you take a picture with the flash at close
range when the zoom is near [W] (1k),
the edges of the recorded picture may
become dark. Rotate the zoom lever
slightly and then take the picture.
Available flash range in Intelligent ISO
sensitivity mode
Shutter speed for each flash setting
¢1 The shutter speed changes depending
on the slow shutter setting. (P63)
¢2 Simple mode [ ]
¢3 Intelligent ISO sensitivity mode [ ]
(P41)/[SPORTS] (P44), [BABY1]/
[BABY2] (P46) and [PET] (P47) in
scene mode
¢2, ¢3: The shutter speed becomes a
maximum of 1 second in the following
cases.
When the optical image stabilizer is set
to [OFF].
When the camera has determined that
there is little jitter when the optical image
stabilizer is set to [MODE1] or [MODE2].
There will be differences in the above
shutter speeds in the following scene
modes.
[NIGHT SCENERY] (P45):
8 seconds to 1/2000th of a second
[STARRY SKY] (P48):
15 seconds, 30 seconds, 60 seconds
[FIREWORKS] (P48):
1/4th of a second, 2 seconds
Do not look directly at the flash at
close range when it is activated.
If you bring the flash too close to an
object, the object may be distorted or
discoloured by the heat or lighting
from the flash.
While the flash is charged, the screen
turns off and you cannot take pictures.
The status indicator lights. [Except
when using the AC adaptor
(DMW-AC6G; optional).]
If the remaining battery power is low,
the screen may be turned off for a
longer period of time.
When you take a picture beyond the
available flash range, the exposure may
not be adjusted properly and the picture
may become bright or dark.
The white balance may not be properly
adjusted if the flash level is insufficient for
the subject. (P56)
[ISO LIMIT]
(P41)
Available flash range
Wide Tele
[ISO400]
Approx.
50 cm to 4.2 m
Approx.
50 cm to 2.6 m
[ISO800]
Approx.
50 cm to 5.4 m
Approx.
50 cm to 3.3 m
[ISO1250]
Flash setting
Shutter speed
(Sec.)
:AUTO
1/30 to 1/2000
:AUTO/
Red-eye
reduction
: Forced ON
: Forced ON/
Red-eye
reduction
: Slow sync./
Red-eye
reduction
1/8
¢1
to 1/2000
: Forced OFF
1/8
¢1
to 1/2000
1/8
¢1
or 1 to
1/2000
¢2
1/4 or 1 to 1/2000
¢3
VQT1C60ENG.book 38 ページ 2007年1月11日 木曜日 午後6時49分