Digital Camera User Manual
Table Of Contents
- TABLE OF CONTENTS
- Before Use
- Preparation
- Standard Accessories
- Names of the Components
- Quick Guide
- Charging the Battery with the Charger
- About the Battery (charging/number of recordable pictures)
- Inserting and Removing the Card (optional)/the Battery
- About the Built-in Memory/the Card (optional)
- Setting Date/Time (Clock Set)
- About the Mode Dial
- Setting the Menu
- About the Setup Menu
- LCD Monitor Display/Switching the LCD Monitor Display
- Basic
- Advanced (Recording pictures)
- About the LCD Monitor
- Taking Pictures using the Built-in Flash
- Taking Pictures with the Self-timer
- Compensating the Exposure
- Taking Pictures using Auto Bracket
- Taking Close-up Pictures
- Taking pictures that match the scene being recorded (Scene mode)
- Motion Picture Mode
- Recording which Day of the Vacation You Take the Picture
- Displaying the Time at the Travel Destination (World Time)
- Using the [REC] Mode Menu
- Taking and viewing clipboard pictures (Clipboard mode)
- Advanced (Playback)
- Connecting to other equipment
- Others
- Screen Display
- Cautions for Use
- Message Display
- Troubleshooting
- Number of Recordable Pictures and Available Recording Time
- Specifications
- Digital Camera Accessory System
- Digital Camera Accessory Order Form (For USA Customers)
- Request for Service Notice (For USA Only)
- Limited Warranty (For USA Only)
- Customer Services Directory (For USA Only)
- Précautions à prendre (pour le Canada)
Advanced (Recording pictures)
34
VQT1J82
∫ Canceling setting
If you press and hold [LCD MODE] again
for 1 second the screen shown in step
2 is
displayed. Select [OFF] to cancel a setting.
• High angle mode is also canceled if you
turn the camera off or power save mode is
activated.
• The brightness of the pictures displayed
on the LCD monitor screen are increased
in Auto Power LCD, Power LCD and High
angle modes. Therefore, some subjects
may look different on the LCD monitor.
However, this does not affect the recorded
pictures.
• The LCD monitor automatically returns to
normal brightness after 30 seconds when
recording in Power LCD mode. Press any
button to make the LCD monitor bright
again.
• If the screen is difficult to see because of
light from the sun etc. shining on it, use
your hand or another object to block the
light.
• Auto Power LCD and High angle mode
are not activated in the following cases.
– When the clipboard is playbacked in
clipboard mode [ ]
– In playback mode [ ]
– In print mode [ ]
– While the menu screen is displayed
– While the review screen is displayed
Taking Pictures using
the Built-in Flash
A Photo flash
Do not cover it with your fingers or other
objects.
∫ Switching to the appropriate flash
setting
Set the flash to match the recording.
1 Press 1 [].
2 Press 3/4 to select a mode.
• You can also press 1 [ ] to select.
• For information about flash settings that
can be selected, refer to “Available flash
settings by recording mode”. (P35)
3 Press [MENU/SET].
• You can also press the shutter
button halfway to finish.
• The menu screen disappears after
about 5 seconds. At this time, the
selected item is automatically set.
:AUTO
The flash is automatically activated when
the recording conditions make it
necessary.
: AUTO/Red-eye reduction¢
1
The flash is automatically activated when
the recording conditions make it
necessary.
It is activated once before the actual
recording to reduce the red-eye
phenomenon (eyes of the subject
appearing red in the picture) and then
activated again for the actual recording.
• Use this when you take pictures of
people in low lighting conditions.
DMC-FX33_ENG.book 34 ページ ２００７年７月９日 月曜日 午後１２時５８分