User guide

Adjusting the position
Use the A and ▼ buttons on the
projector or remote control unit to
select an item, then press the
ENTER button or the ◄ or ►
buttons to display the adjustment
screen, and then use the ◄ or ►
buttons to make the adjustment.
When an RGB/YPbPr signal is
being input
POSITION
t S E L C T tWtIM ENTER ESC
When an S-VIDEO/VIDEO signal is
being input
^ Z. 1=
t S E L C T EH7EiqE N T E R HENH ESC
HORIZONTAL POSITION
Press the ◄ button to move the
picture to the left, and press the ►
button to move the picture to the
right.
VERTICAL POSITION
Press the ◄ button to move the
picture down, and press the ►
button to move the picture up.
VIDEO SIZE
(S-VIDEOA/IDEO only)
Press the ◄ button to make the
picture smaller, and press the ►
button to make the picture larger.
DOT CLOCK
(RGB only)
Periodic striped pattern interference
(noise) may occur when a striped
pattern such as the one below is
projected. If this happens, use the
◄ and ► buttons to adjust so that
any such noise is minimised.
CLOCK PHASE
(RGB only)
Adjust the DOT CLOCK setting first
before carrying out this adjustment.
Use the ◄ and ► buttons to adjust
so that the noise level is least
noticeable.
NOTE:
• When an UXGA signal is being
projected, interference may not
be completely eliminated when
the DOT CLOCK and CLOCK
PHASE adjustments are carried
out.
c
(D
1-
d>
a
O
o
CO
CQ
33