Owner manual

14
RQT9048
Recording Set Top Box Programs
Refer to “Important Notes for Recording” (➔ 17) and “Advanced Recording” (➔ 18, 19) for detailed information on
recording.
RAM
-R -R DL -RW(V) +R +R DL +RW
Preparation:
Turn on the television and select the appropriate video input to suit the
connections to this unit (Example: AV input).
When using the set top box, make sure it is turned on.
RAM
If the disc is protected, release protection (➔ 40).
•
•
•
to turn the unit on.
“HELLO” appears on the unit’s display.–
; OPEN/CLOSE
to open the tray (Button located on the upper front of the unit).
Insert a disc with enough remaining blank space and press
[
;
OPEN/CLOSE] again to close the tray.
–
3a
When the set top box is controlled with this unit:
to select desired channel.
or
3b
When the set top box is not controlled with this unit:
to select “IN1” or “IN2”.
Select a channel on the connected equipment.–
to select the recording mode.
Recording mode should be determined by program length and
available time on the disc (➔ 18).
Recording mode
Remaining time
–
to start recording.
REC
Pausing Recording
Press [
h
PAUSE].
Press again to restart recording.–
Stopping Recording
Press [
g
STOP].
3a
Tips
Icons such as “
RAM
” indicate usable
discs. Refer to pages 55 and 56.
•
Notes
-R -R DL -RW(V) +R +R DL +RW
It takes about 30 seconds for the unit
to complete recording management
information after recording finishes.
You cannot change the channel or
recording mode during recording.
•
•
3b