User manual

18. Materials
558
0 If [Focus/Shutter Priority] is set to [FOCUS], then recording will not take place until
focus is achieved. (l 421)
0 Images may look whitish when the lens or image sensor gets dirty with fingerprints or
similar.
If the lens is dirty, turn the camera off, then wipe the lens surface with a soft, dry
cloth.
For information about how to clean the image sensor, refer to page 571.
0 Ensure AE Lock is not set where it is not appropriate. (l 199)
0 When drive mode is set to [ ] (Burst Shot 1) or [ ] (Burst Shot 2), pressing
and holding the shutter button will take burst pictures. (l 131)
0 When [Bracketing] is set, then pressing the shutter button records multiple images
while automatically changing the settings. (l 160)
0 Confirm the following details:
– Is the subject outside of the focus range?
– Is [Shutter AF] set to [OFF]? (l 424)
– Is [Focus/Shutter Priority] set to [RELEASE]? (l 421)
– Is AF Lock (l 199) set where it is not appropriate?
0 The shutter speed will become slower and the image stabiliser function may not
work properly when recording in dark places.
In these cases, use a tripod and the self-timer when recording.
Cannot record images.
The shutter will not operate immediately when the shutter button is
pressed.
The recorded image is whitish.
The recorded image is too bright or dark.
Multiple images are recorded at once.
The subject is not focused properly.
The recorded image is blurred.
The image stabiliser is not effective.